5 ms·

My Maytag Neptune retains so much water from the previous load, that leaving it open is absolutely ineffective. It molds after 3-4 days no matter what. I can sp

My Maytag Neptune retains so much water from the previous load, that leaving it open is absolutely ineffective. It molds after 3-4 days no matter what. I can spin the drum after leaving it open for 2 weeks, and it still makes a pronounced sloshing noise, there's still a ton of water left in there. I suspect this was meant to reduce the fill water used in the subsequent load, but that's only sensible if you're doing laundry every day or two. If you go longer between washing sessions, it's just making clothes stinky. Perhaps it's backwash from water left in the discharge hose after the pump shuts off? So for years, I just run the first cycle empty, hot, with a bunch of bleach. It wastes more water than this stupid measure could ever possibly save, but it keeps my clothes from being stinky. That machine was just damaged in a flood so I'm shopping for a replacement as I write this, and I cannot for the life of me find this information in any reviews. Does it drain fully? How much water is left behind? A friend pointed out that some machines have a little pigtail hose out the back with a manual drain valve on it, presumably meant to completely empty the machine before transport. Their theory is that I could put a solenoid valve on this and install my own tiny pump to finish draining the machine after a session, possibly a peristaltic pump which wouldn't be susceptible to backflow from the lift. But again, I can't find information in the reviews about whether any given new machine I might buy, has this little drain pigtail.

cmrdporcupine 1y ago
I too am very annoyed by the "save water" trend in appliances that then produce inferior results. Yes, I know there are parts of the world where this is a concern, but I'm in the great lakes region on a well that produces 20GPM of water and I do not have this concern. Water for me is copious and basically free and when I'm done with it it goes into my septic to reabsorb into the water table. We switched from a front loading washer back to a top-loading one hoping we'd get results similar to the top-loading washers from our youth. But nope. Funky smells, poor distribution of detergent, clothes that don't fully clean.
- User23 1y ago
  You want a Speed Queen. It’s the closest you can get to an older washer.
- jihadjihad 1y ago
  > We switched from a front loading washer back to a top-loading one hoping we'd get results similar to the top-loading washers from our youth. But nope. As sibling comment says, get yourself a Speed Queen, made with commercial parts and still washes the good old fashioned way [0]. 0: https://speedqueen.com/speed-queen-difference/#classic-clean https://speedqueen.com/speed-queen-difference/#classic-clean
  - cmrdporcupine 1y ago
    Doesn't look available in Canada, and I wouldn't buy from an American company now anyways.
sumtechguy 1y ago
When I first switched to the front load washer I started getting a terrible smell pretty quickly. How I got rid of it. 1) do not use liquid detergents. powder only. My working theory is the medium used to make it gooey was sticking and giving the mold a good medium to live in. 2) do not use liquid fabric softeners. see #1. I use a fabric sheet on drying. 3) clean cycle once a month 4) washer tablet in with the wash clean cycle, I alternate with bleach every other month. 5) leave the door open between washes 6) drain out the water from the 'pigtail' once every 6 months, or whatever the documentation recommends. It is not just for when you move it. It is meant for the next step. 7) clean out the lint trap. Many have this just before the drain out and before the pump. That thing can get really gunked up. especially with liquid detergents/softners. I use the same schedule as the drain out. #1 and #2 were the main sources for me. Took about 2-3 weeks before the smell was gone. For my samsung I would say about a 1/4 gallon is left in the hoses.
- HPsquared 1y ago
  I'm lucky enough in terms of layout that I can leave the door wide open AND the detergent drawer open when it's not in use. That allows a kind of "fresh air circulation" between the drawer and the door. That ventilates the whole system. I don't get any smells. I use powder detergent, no cleaning cycles except the occasional wash at 90 Celsius. This is a UK machine though, US may be different.
- mprev 1y ago
  A note on liquid versus powder detergents. In the UK, at least, my understanding is that liquid detergents do not contain bleaching agents, whereas powders do. That is, unless you buy a colour-safe powder. If you're pouring bleach into your machine, it can erode the rubber seals. I use Dettol instead (I think it's called Lysol in the States), which seems to do the job.
  - sumtechguy 1y ago
    A bit of bleach once and awhile is ok. There is even a spot for it to be put in on the detergent tray. I do not use it all the time. I stick to the powder and a cup or so of bleach every now and then on a clean cycle (once or twice a year). Pretty sure it is a color safe powder I am using.
dsego 1y ago
> there's still a ton of water left in there. Sounds like is not draining properly, is it clogged up? Should use some vinegar on an empty cycle to descale the heater and all the drain holes.
tzs 1y ago
> I can spin the drum after leaving it open for 2 weeks, and it still makes a pronounced sloshing noise, there's still a ton of water left in there. Is it a top loader? If so double check to make sure you are really hearing left over washing water and not balancing water. Most top loaders have a sealed hollow ring around the drum, usually near the top but sometimes at the bottom, that is partly filled with water or a saline solution. The liquid in the ring redistributes itself around the drum during spin cycles in a way that counters an off balance load in the drum which reduces vibration and noise. If you spin the drum by hand the balancing liquid sloshes around and it can be quite noticeable on some washers. Next time you are at an appliance dealer try spinning the drums in some of the top loaders on display. It can sound like a surprisingly large amount of water.
- myself248 1y ago
  It's a front loader.

cmrdporcupine 1y ago

I too am very annoyed by the "save water" trend in appliances that then produce inferior results. Yes, I know there are parts of the world where this is a concern, but I'm in the great lakes region on a well that produces 20GPM of water and I do not have this concern. Water for me is copious and basically free and when I'm done with it it goes into my septic to reabsorb into the water table. We switched from a front loading washer back to a top-loading one hoping we'd get results similar to the top-loading washers from our youth. But nope. Funky smells, poor distribution of detergent, clothes that don't fully clean.

User23 1y ago
You want a Speed Queen. It’s the closest you can get to an older washer.
jihadjihad 1y ago
> We switched from a front loading washer back to a top-loading one hoping we'd get results similar to the top-loading washers from our youth. But nope. As sibling comment says, get yourself a Speed Queen, made with commercial parts and still washes the good old fashioned way [0]. 0: https://speedqueen.com/speed-queen-difference/#classic-clean https://speedqueen.com/speed-queen-difference/#classic-clean
- cmrdporcupine 1y ago
  Doesn't look available in Canada, and I wouldn't buy from an American company now anyways.

sumtechguy 1y ago

When I first switched to the front load washer I started getting a terrible smell pretty quickly. How I got rid of it. 1) do not use liquid detergents. powder only. My working theory is the medium used to make it gooey was sticking and giving the mold a good medium to live in. 2) do not use liquid fabric softeners. see #1. I use a fabric sheet on drying. 3) clean cycle once a month 4) washer tablet in with the wash clean cycle, I alternate with bleach every other month. 5) leave the door open between washes 6) drain out the water from the 'pigtail' once every 6 months, or whatever the documentation recommends. It is not just for when you move it. It is meant for the next step. 7) clean out the lint trap. Many have this just before the drain out and before the pump. That thing can get really gunked up. especially with liquid detergents/softners. I use the same schedule as the drain out. #1 and #2 were the main sources for me. Took about 2-3 weeks before the smell was gone. For my samsung I would say about a 1/4 gallon is left in the hoses.

HPsquared 1y ago
I'm lucky enough in terms of layout that I can leave the door wide open AND the detergent drawer open when it's not in use. That allows a kind of "fresh air circulation" between the drawer and the door. That ventilates the whole system. I don't get any smells. I use powder detergent, no cleaning cycles except the occasional wash at 90 Celsius. This is a UK machine though, US may be different.
mprev 1y ago
A note on liquid versus powder detergents. In the UK, at least, my understanding is that liquid detergents do not contain bleaching agents, whereas powders do. That is, unless you buy a colour-safe powder. If you're pouring bleach into your machine, it can erode the rubber seals. I use Dettol instead (I think it's called Lysol in the States), which seems to do the job.
- sumtechguy 1y ago
  A bit of bleach once and awhile is ok. There is even a spot for it to be put in on the detergent tray. I do not use it all the time. I stick to the powder and a cup or so of bleach every now and then on a clean cycle (once or twice a year). Pretty sure it is a color safe powder I am using.

dsego 1y ago

> there's still a ton of water left in there. Sounds like is not draining properly, is it clogged up? Should use some vinegar on an empty cycle to descale the heater and all the drain holes.

tzs 1y ago

> I can spin the drum after leaving it open for 2 weeks, and it still makes a pronounced sloshing noise, there's still a ton of water left in there. Is it a top loader? If so double check to make sure you are really hearing left over washing water and not balancing water. Most top loaders have a sealed hollow ring around the drum, usually near the top but sometimes at the bottom, that is partly filled with water or a saline solution. The liquid in the ring redistributes itself around the drum during spin cycles in a way that counters an off balance load in the drum which reduces vibration and noise. If you spin the drum by hand the balancing liquid sloshes around and it can be quite noticeable on some washers. Next time you are at an appliance dealer try spinning the drums in some of the top loaders on display. It can sound like a surprisingly large amount of water.

myself248 1y ago
It's a front loader.