3 ms·
Commercial injection modeling is going to be at the rate of perhaps a thousand per hour, not per shift. Many parts will be set up so that a single "hit" of the
by TylerE 14y ago
Commercial injection modeling is going to be at the rate of perhaps a thousand per hour, not per shift. Many parts will be set up so that a single "hit" of the mold can produce dozens of parts.
In manufacturing, processes are used that have a minimum number of steps. Cycle time is critical. Even CNC doesn't have that much penetration outside of a very few select industries, namely aerospace and some automotive. Very little, if anything, on a consumer product will be CNC made, for much the same reasons 3D printing will have a very hard time catching on for production.
One real niche for CNC is actually making molds for injection molding - that's one case where taking dozens of hours to cut a single part isn't a problem, as that one mold can stamp hundreds of thousands of parts.
Source: I'm actually a manufacturing engineer by training.
EDIT: And yes, I think 10 years is much too soon. Industry has a huge amount of money invested in existing factories. Much of that equipment is useable for decades to come. You would have to get quite a bit better than the existing standard for them to even think about replacing the existing lines.
- ChuckMcM 14y agoAwesome, I disagree of course but its a great discussion. My experience is with the integration of low cost compute into the flows rather than manufacturing. However I find it striking how similar your argument sounds to the ones that IBM made early on about how PCs would 'never' threaten mainframes because they didn't have the IO capabilities or the printing capability. And while certain markets still use them (credit card processing for example), a lot of things they were used for succumbed to a new way of doing things because it was cheap. I suspect that much of the challenge with CNC penetration is with the costs involved. But could easily be wrong. Current injection molding does make thousands per hour and that's certainly achievable with thousands of 3D printers running in parallel, but the place where I think you will first see disruption will be in the 'short run' segments, where people would make 100,000 parts (minimum run) and only sell 10,000 units. Their price per unit was effectively 10x in that case. But they have no other way to get to 10,000 at the moment. In the compute space that is how the market disrupted, lower performance of the unit offset by the savings of not having to over provision for the compute capacity. Will be interesting to watch.