4 ms·
This. If you have any interest in manufacturing, IMO the turbine blades in a jet engine are incredible. Without going into loads of detail, 2 points that blow
by screwt 14y ago
This.
If you have any interest in manufacturing, IMO the turbine blades in a jet engine are incredible.
Without going into loads of detail, 2 points that blow my mind:
1) Due to compression in the intake (and as per the ideal gas law D_Alex mentions above), the temperature of the air when it reaches the turbine is higher than the melting point of the turbine blades. The workaround for this is the blades are made with hollow channels through which cold air is blown, keeping them just cool enough.
2) You may be familiar with 'creep' - where materials under stress gradually relax to relieve that stress, even when the stress is lower than the yield stress of the material. Creep is made worse by (i) repeated stress cycles and (ii) high temperatures. In a typical jet turbine engine, you have blades spinning at 10000 rpm, at high tempratures, with a few microns clearance to the edge of the turbine housing. If they were to elongate and rake the edge of the housing at that speed ...
- yock 14y agois point 1 typical for all turbojet & turbofan engines, or is this specific to then J58?
- tcas 14y agoOn modern jet engines: yes. There's a documentary / video about the manufacture of the Rolls-Royce Trent engine that mentions this fact and shows a CAD drawing / part of the manufacture process of the blades right after the combustion stage.
- SageRaven 14y agoPoint #1 is pretty cool. I worked as an IT intern for Pratt and Whitney in the Middletown, CT plant in the mid 90's. I got to see samples of the blades straight from the factory floor, and indeed they had those cool-looking grooves and channels in the them. My occasional trips to the shop floor for some PC maintenance or another was really the coolest part of that job.
- tcpekin 14y agoPoint #2 is also pretty cool. In order to prevent overcome problems of creep, the turbine blades can be made in a single crystal [1] [2]. This prevents much/all of the creep, as creep is associated with grain boundaries. It's pretty phenomenal that these single crystals can be manufactured into jet turbine blades. [1] http://www.appropedia.org/Single_Crystal_Turbine_Blades http://www.appropedia.org/Single_Crystal_Turbine_Blades [2] http://www.freepatentsonline.com/6673308.html http://www.freepatentsonline.com/6673308.html *edit fixed links.
- judgardner 14y agoran into this graphic while installing some modeling software awhile back, shows thermal stress on the blades http://www.comsol.com/products/multiphysics/ http://www.comsol.com/products/multiphysics/
- ubasu 14y agoNitpick: creep is different from relaxation. Creep is when you apply a constant load on the material, and the material elongates (creeps) gradually, keeping the same stress. Relaxation is when you apply a constant extension to the material, and the stress reduces gradually (material relaxes), keeping the same extension.