2 ms·
> some challenges in sealing it It's a 1 atm difference, so even adhesive tape stuck on the inside would do the trick. Unfortunately, I don't think there is mu
by rbanffy 2y ago
> some challenges in sealing it
It's a 1 atm difference, so even adhesive tape stuck on the inside would do the trick. Unfortunately, I don't think there is much unexposed hull on the inside and I bet the crack is behind some equipment that isn't trivial to remove (or else it'd have been found years ago by some annoyed astronaut in their off-time).
Detecting from the outside is also complicated, as you'd need to release (and reattach) the thermal blankets to see the actual surface of the module.
Closing the hatch and stopping the use of that docking port seems to be the smart thing to do. Worst case scenario, repressurise, dock the Progress, unload, load it with trash, and close the hatch. I also don't think anyone is considering using this module to boost the station's altitude - I would't put any additional stresses on it anyway.
- schiffern 2y agoTrue, but also sealing the leak is only putting a bandaid over the problem. The hull is still going to fail eventually. A better fix would be (believe it or not) drilling holes in it, then sealing it over. This "stop drilling" prevents the crack from growing any larger. https://old.reddit.com/r/engineering/comments/6bdugb/how_does_stop_drilling_arrest_metal_crack/ https://old.reddit.com/r/engineering/comments/6bdugb/how_doe...