4 ms·
Z in a positive direction should always be up on a 3-axis machine --- the only time it might even appear not would be if the machine was already even higher tha
by WillAdams 2y ago
Z in a positive direction should always be up on a 3-axis machine --- the only time it might even appear not would be if the machine was already even higher than that position.
- LorenPechtel 2y agoOne would think so, but apparently it varies between manufacturers. Our machines are all carving up a flat surface resting on a table. I think what's going on is that functionally that means that the working head is permanently upside-down. Is Z measured in the context of the whole machine, or is Z measured in the context of the cutting assembly?