3 ms·
What these results tell me is that it is probably possible for users to modify their slicer settings to get similar performance. It took an LLM to notice t
by al2o3cr 2y ago
What these results tell me is that it is probably possible
for users to modify their slicer settings to get similar performance.
It took an LLM to notice that 170k lines of G-code was probably not typed in by hand?
Despite numerous tries, I couldn't get an answer about what slicer
settings to change to get the G-code I produced using their slicer
to perform as well as the G-code generated using their slicer.
Did the paragraph where the LLM identified those settings get lost on the editing-room floor?