4 ms·
That tool is for someone who needs to maximize battery life for a small device. For higher powered DC loads, there are Hall effect sensors. These usually come
by Animats 2y ago
That tool is for someone who needs to maximize battery life for a small device.
For higher powered DC loads, there are Hall effect sensors. These usually come as plastic-enclosed devices with a hole in them, through which you route one of the high-current wires. They need some DC power, usually 5V or so, and you get a voltage out proportional to the current. They sense the magnetic field from the wire, without requiring a direct connection, which is good when you're measuring high current, high voltage, or both. Some have a split ring so you can install the sensor around an existing wire without cutting it.
For AC, there are current transformers, which install the same way, and put out a small current in a fixed ratio to the current in the wire being sensed.
The hand-held version is a clamp-around AC/DC current meter, a common tool.
These are all standard, modestly priced items.
- tomtranter 2y agoI used Hall effect sensors for a project and found they needed a fair bit of calibration. Shunt resistors also did the job with fewer problems but this was a 16p2s module.
- Animats 2y ago> I used Hall effect sensors for a project and found they needed a fair bit of calibration. From AliExpress?
- exmadscientist 2y agoHall sensors have a lot of issues. If you can handle the power dissipation in the resistor, a shunt plus a fancy zero-drift difference amplifier is almost always going to be superior. Hall sensors win for very high currents, high bandwidths, and when isolation or noninvasive measurement is required.
- Animats 2y agoTechnically, yes. That's how most meters work. But now you have high current, high voltage, and isolation issues in your sensing device. So you need more testing and approvals.