The CRT fired in sync with its input signal, not the other way around. Timing was done through HSYNC and VSYNC as well as the blanking intervals - the area afte

The CRT fired in sync with its input signal, not the other way around. Timing was done through HSYNC and VSYNC as well as the blanking intervals - the area after the sync signals where no image signal was to be sent. VSYNC was locked to the net frequency on televisions and early monitors but could be configured within certain bounds on later models, HSYNC depended on the intended vertical resolution ((Vres + blanking/shelf) * VSYNC = HSYNC), the dot clock decided the horizontal resolution. Positioning was relative and depended on how the monitor was adjusted - horizontal and vertical deflection, pillow deformation, trapezoidal deformation, etc. CRT tubes had no concept of 'pixels', those were a function of the dot clock/HSYNC/VSYNC. Colour tubes had RGB triplets in either delta shape - three dots in a triangle in combination with a shadow mask with round holes - or next to each other for in-line, those with either a shadow mask (a metal plate with loads of slits) or a wire mask (thin vertical metal wires strung between the top and bottom of the CRT. There was no fixed relation between display pixels and those triplets, especially on later high-bandwidth multi-sync monitors this could result in display pixels taking up less than a colour triplet which led to odd colour effects on small details. I used a 17" CRT at 1600x1200 which often showed such effects on the small fonts I tend to use so as to cram as much as possible on the screen.