3 ms·
it'll help a lot with shear failures between layers, but only very slightly with tensile failures between layers. and if i'm not mistaken, tensile failures are
by kragen 3y ago
it'll help a lot with shear failures between layers, but only very slightly with tensile failures between layers. and if i'm not mistaken, tensile failures are the bigger problem
crinkle crankle walls are that way to make them strong in flexure, so they don't just fall over when the wind hits them (failing in tension in the mortar joints between the bricks at the base on the windward side). that particular failure mode isn't relevant here because the other layers of the print already protect against that
- Doxin 3y agoIt'd significantly increase surface area between the layers, wouldn't it? I can only imagine that makes for a lot better layer adhesion.