3 ms·
I can't tell if you are forcing your point or not, but I have to correct. You're doing through hole wrong: that way will take forever to do a board. Stuff the
by HeyLaughingBoy 15y ago
I can't tell if you are forcing your point or not, but I have to correct. You're doing through hole wrong: that way will take forever to do a board.
Stuff the board with the smallest height components. Place a compliant material on top of the board (e.g., firm foam rubber). Flip board over and solder all components. Put iron down. Cut leads. Flip board over and repeat for next highest components.
This minimizes the number of tool swaps and handling and is very fast.
That said: I much prefer SMT soldering and I don't even use an iron anymore, even for just one board: manually dispense paste on all the pads. Place all components at once. Put in toaster oven. Bake (I manually adjust the profile while watching the clock). Remove perfectly soldered boards. But yeah, I won't do anything smaller than 0805 or 0.5mm pitch QFP just yet :-)
- AnthonBerg 15y agoHahha, forcing a point yes, but also just being a little thick and not 'getting' the foam-pad method. THANK YOU. In real life, doing many through-hole components at once, I have tack soldered them top-side - when possible, e.g. resistors, not possible for radial caps.
- DanBC 15y agoIn production environments you buy special frames for that method. You can also get "cropping plates" and "cropping machines". A cropping plate is a sheet of steel with holes drilled for all through-hole component leads. You place a few PCBs on it, then stuff all components. You then place the plate on the cropping machine, which has "drop down pins" to hold the components in place and sliding blades under the plate which scrape / cut the leads off. You then take the PCBs off the plate and put them through a wave solder machine. One potential problem with tacking topside (and this is more theoretical than real) - sometimes the through hole plating is cracked. On a multilayer PCB this may mean that you don't have proper connection between all layers. If you only solder from the bottom of the board you can see if the solder has correctly flowed. Some high-spec jobs will forbid soldering on the topside. (Aerospace, etc.)