3 ms·
See also, FluxEngine: http://cowlark.com/fluxengine/index.html http://cowlark.com/fluxengine/index.html The hardware is just an off-the-shelf fpga dev board wi
by Brian_K_White 3y ago
See also, FluxEngine: http://cowlark.com/fluxengine/index.html http://cowlark.com/fluxengine/index.html
The hardware is just an off-the-shelf fpga dev board with the 34-pin connector soldered directly to it. That's it. No other components or pcb or anything.
https://photos.app.goo.gl/aDKggy7UAHsyLj717 https://photos.app.goo.gl/aDKggy7UAHsyLj717
You extract pin #5 from the connector and solder the entire odd row to gnd (one wire and there is a gnd pad right at the end of the connector) and snap off the programmer board. Done.
- MrBuddyCasino 3y agoNice, also the PSoC5LP CY8CKIT-059 is cheap and can be had for ~20 €.
- guenthert 3y agoI was a bit surprised about the use of a FPGA directly connected to a 5V bus, but Infinion/Cypress describes their CY8C58LP as 'programmable system on a chip' (ARM M3 core, the usual set of interface subsystems and a few 'universal digital blocks' (like a mini FPGA). And yes, it is 5V tolerant. Looks interesting. https://www.infineon.com/dgdl/Infineon-PSoC_5LP_CY8C58LP_Family_Datasheet_Programmable_System-on-Chip_(PSoC_)-DataSheet-v15_00-EN.pdf?fileId=8ac78c8c7d0d8da4017d0ec547013ab9 https://www.infineon.com/dgdl/Infineon-PSoC_5LP_CY8C58LP_Fam...