2 ms·
I had one of these. From the pictures, I cans see it was was the 200-in-one. I built things from the book, and tinkered, but didn't really learn anything from
by kazinator 3y ago
I had one of these. From the pictures, I cans see it was was the 200-in-one.
I built things from the book, and tinkered, but didn't really learn anything from that.
I got into it properly circa 2012. I probably learned more in one week than I ever did from tinkering with that. Electronics requires proper study. For any circuit of moderate complexity, your intuition for what is happening will be poor without the background. The hands-on experience and familiarity that brings about is great, and it was a lot of fun, I always had this lingering dissatisfaction that I don't know what's going on.
I had a computer in parallel with this, and that soaked up my tech-oriented attention.
One problem I remember is that the coil-spring connection method in the kit had reliability issues. The contact produced by a wire clipped into a tiny spring isn't always very good, and if you have a few dozen of them which all have to be good for the circuit to work, the odds work against you. Today I understand why; most likely the layers of oxidation on the wire and coil are the culprit. When you clip the stripped wire end into the coil, there isn't a sliding motion there, or not always, that will break through the oxidation. I suspect the springs are just ordinary spring steel springs, not coated with anything for promoting good contact, like nickel.
If I had one of these kits today, I would give it some TLC to make it more reliable.