5 ms·
This will come from all ground transportation sources, right? Busses, trains, trams, subways etc. Probably the heavier the vehicle the more particles are likel
by ThinkBeat 3y ago
This will come from all ground transportation sources, right?
Busses, trains, trams, subways etc.
Probably the heavier the vehicle the more particles are likely to be produced?
- rightbyte 3y agoHeavy vehicles like busses and trucks more often have drum brakes which I guess are better from a air pollution view?
- adgjlsfhk1 3y agodrum breaks have the breaks enclosed so the particles won't be in the air
- rickydroll 3y agoIf you've ever worked on a vehicle with drum brakes, you would see the foolishness in your statement. Brake dust goes everywhere, whether it be drums or disc brakes. Older drum brakes were even more hazardous because the brake linings were built with asbestos, at least until the 1990s for US-made brake products. Aftermarket and foreign-made brake pads apparently still have asbestos in them. I'm not too worried about this. It's an engineering problem and now that is been raised, we can find solutions.
- FredPret 3y ago> It's an engineering problem and now that is been raised, we can find solutions. This should be the default attitude of society
- akira2501 3y agoIt should at least be the default attitude on this site.
- londons_explore 3y ago> It's an engineering problem and now that is been raised, we can find solutions. Engineers won't be permitted to spend any time or dollars solving this till there is a law capping particulate emissions.
- kube-system 3y agoDrum brakes that I've worked on often have a lot of dust in the drum. Which is a good thing because all of that dust is not in the air. But of course they are not anywhere close to being sealed.
- porkbeer 3y agoNot really. Most brake dust falls from the drums by design.
- aceazzameen 3y agoBeing on or near a train platform and you can see brake dust caked on everything. Probably dust combined with grease. It's worse looking than roads.
- Gigachad 3y agoI’m pretty sure they grease the rails in some spots, particularly the curvy bits that are often near platforms so it would get stuck to the rails and such. Cars would put out massively more pollution but it’s more free to blow around in the wind. I had some boxes stored in a storage cage in my apartment car park and after 6 months sitting there, they were all coated in a thick black dust. Since there was no wind or rain to move it around, it just settles and builds up.
- Tade0 3y agoI could always smell iron filings when standing on an enclosed train platform. There's definitely something floating around there.
- aceazzameen 3y agoThey don't grease the cross beams on ceilings though, and those things are nasty in train stations. Same stuff you see creeping up the walls around the tracks in the subway tunnel. Not a competition though, the pollution is bad and we're all so used to it.
- Gigachad 3y ago>Not a competition though It is quite important to discuss exactly where the top sources of pollution are through so we can cut back on the worst sources of them to have the most impact.
- ninininino 3y agoAll wheeled ground transportation sources that use brakes. Legged vehicles and ground effect vehicles would not suffer from this problem, and we shouldn't necessarily assume the wheel will be the forever solution, we should not fail to dream.
- fddrdplktrew 3y agoFrom airplanes, you get the lead from their fuel
- AnarchismIsCool 3y agoOnly very small piston airplanes, and the need fuel is being phased out. Areas immediately surrounding heavily used ga airports are occasionally seeing elevated levels but it's not a particularly potent source for the public. The issue is mostly employees at the airport being exposed while fueling and performing maintenance.
- fddrdplktrew 3y agowhy are they still using it?
- AnarchismIsCool 3y agoPartly because boomers, partly because the FAA is bad at their jobs.
- porkbeer 3y agoThey want a perfect changeover where new fuel can run in old engines. Problem is general aviation is stick in the 1950s, and dont want to have to replave their valve seats with hardened ones.