2 ms·
Than stainless steel! If you have two resistors in parallel, the current in each is proportional to the ratio of the resistances. But what if one of the resist
by Animats 3y ago
Than stainless steel!
If you have two resistors in parallel, the current in each is proportional to the ratio of the resistances. But what if one of the resistances is zero? Then all the current goes through that resistor. So if you have a superconductor in parallel with another resistor, all the current goes through the superconductor! Doesn't matter if the other resistance is very, very low, but still nonzero.
Reportedly some undergrad thought of this.
So the superconducting layer is bonded to stainless steel tape, which is strong, not brittle, and will go down to cyrogenic temperatures without problems. Most previous superconducting "wires" had brittle ceramic insulation, which was hard to wind into magnets.
This is really clever.
- pfdietz 3y agoThe other thing the normal conductor does is save the coil from exploding if the superconductor quenches and loses its superconductivity (1/2 L I^2 can be a lot of energy). Old low Tc superconductors used copper for this, I believe.
- raziel2701 3y agoI think there's another level to this, when you put a superconductor in contact with a metal there's a proximity effect that lowers the Tc of the superconductor. If you're using a superconductor that has a 4K Tc then you cannot afford to have your superconductor be weakened by the proximity effect. So the insulation is to prevent the proximity effect from happening. Here, since you're using a much higher Tc material, if Tc is lowered by a few K you still have plenty of thermal budget, allowing you to take the hit from the proximity effect but be able to save on insulation.
- chasil 3y agoDo any of these principles apply to liquid nitrogen applications? The article outlines a plate design that incorporates steel/REBCO windings and cooling channels for liquid helium that seems to be modular and easily serviced. REBCO is actually listed as a high-Tc material in the wiki below, but requires liquid helium. If this were reworked into a liquid nitrogen design, could it reach 20 Tesla? https://en.m.wikipedia.org/wiki/High-temperature_superconductivity https://en.m.wikipedia.org/wiki/High-temperature_superconduc...
- namibj 3y agoI think a better question is whether it's compatible with hydrogen, because 20K is plenty cold enough for REBCO, just not for classic Type-1 superconducting wire in magnets.