5 ms·

I was just researching that — theoretically, you could run any substance through the printer, right? But some substances will cause problems. Software is an iss

I was just researching that — theoretically, you could run any substance through the printer, right? But some substances will cause problems. Software is an issue too, but hopefully there’s a way to hijack whatever Preform does. As for mess, I got a Form Wash and Form Cure, so odor is the only issue. But we’re planning to stick the whole thing in a grow tent if it’s a problem. https://youtu.be/IIWEV9AM8-k?si=cKyJR0caBu8s3odo https://youtu.be/IIWEV9AM8-k?si=cKyJR0caBu8s3odo shows the full setup.

yakz 3y ago
Just the tiny splatter from pouring or manipulating the resin makes a mess, it can take a while to build up to being visible. It’s hard to clean away once cured. You can use any substance with a printer that the hardware and software supports and then some. But your common DLP or galvo resin printer is just going to be for light-cured baths.