2 ms·
If the power lines to the processor were not connected, then what leakage was powering it? Was it running only off the minimal electricity transmitted when data
by stephengillie 15y ago
If the power lines to the processor were not connected, then what leakage was powering it? Was it running only off the minimal electricity transmitted when data was moved into/out of the processor?
- justincormack 15y agoApparently so; one of the comments said they realized what was happening as it would crash when all the input lines were zero.
- rcxdude 15y agousually CMOS chips have input protection diodes which prevent the input pins from rising too high above the power lines or too far below ground, which causes SCR latchup - essentially a short from power to ground. This also means that CMOS chips can often be powered by input pins alone. I've even experienced this with a stepper motor driver which didn't have the main power lines hooked up (but did have logic power), where 3A were going through these diodes to run the motor. So I'm not sure how that particular anecdote says much about the power usage of the ARM chip.