4 ms·
It's far from a foolproof process. You have to be careful with choosing paper (RC vs FB is one choice, and RC is much better than it was in the 70's but I woul
by klodolph 15y ago
It's far from a foolproof process. You have to be careful with choosing paper (RC vs FB is one choice, and RC is much better than it was in the 70's but I wouldn't consider it "archival", some FB paper may be acid free but still contains whitening chemicals which caused problems in the past) and the chemicals and washing process has to be done properly (it's easy to get contamination in the wash water, hypo in the final print will cause fading over time). Then you have to store it properly. If you frame it, you have to worry about the air in the frame -- there are stories of prints framed during building renovation that degraded since the frame trapped air containing chemicals from the construction. Tape is also a serious issue if you use tape (which is the best way to frame prints).
"Permanent" is such a strong word. Sure, 100 years, if you get all of the above right.
Getting well past 100 years is simply not within the range of simple silver gelatin prints; the silver will corrode due to the same process that causes silver jewelry to tarnish. True archival stability requires toning. You have three good options: sulfide, selenium, or gold. Sulfide (or "sepia") has a striking brown color which reminds you of old photographs. That's because only the old photographs which were toned survived -- the neutral colored black and white photographs faded long ago. Selenium has a more mellow black/brown color depending on the dilution, and can be made fairly neutral. It is generally preferred over sulfide. Gold, on the other hand, provides a slightly cooler tone (blue or green is possible, if you use enough of it) but it's expensive enough that the cost of the gold can be a significant fraction of the material cost. (Old gold-toned photos survive too, but they're rarer.) (Not all toners increase permanence, e.g., iron-based toners can give you a cheaper blue than using gold but they're water-soluble.)
On the other hand, an inkjet can be loaded with carbon-based pigments. Carbon-based pigments can be found on cave paintings in France dating back 32,000 years, so they should be stable enough.
I have no doubt that a good inkjet print with carbon-based inks will outlast all of my darkroom prints. In my mind, color inkjet prints have far surpassed color darkroom prints, but that's not as hard as it sounds.