3 ms·
The shaft is a part of the existing rotisserie device. The shaft has a square cross-section and it can accept various mountable attachments, e.g. [1] and [2]. T
by huhtenberg 3y ago
The shaft is a part of the existing rotisserie device. The shaft has a square cross-section and it can accept various mountable attachments, e.g. [1] and [2]. They all use collets, so I'm just following their design here.
Force-wise - about a pound of load per "arm", give or take, not much really.
Re: screw holes - noted, thanks.
[1] https://www.amazon.com/GRILLJOB-Stainless-Rotisserie-1-Pair-Hexagon/dp/B08TTKP5V2 https://www.amazon.com/GRILLJOB-Stainless-Rotisserie-1-Pair-...
[2] https://www.amazon.com/-/en/25437-R%C3%B6sle-High-Quality-Barbecue-Skewer/dp/B08QJKZWB4 https://www.amazon.com/-/en/25437-R%C3%B6sle-High-Quality-Ba...
- Scene_Cast2 3y agoIn that case, if you make your mounting part a square or rectangular block instead of a cylinder, this way you can avoid the use of a lathe. Or if you spec the outside diameter of your cylinder to be some common size (+/- some loose tolerance), then that would avoid machining the outside (as there's cylindrical metal slock). I also realized that my original suggestion of "set screw on the bottom part" is also probably hard to manufacture.
- huhtenberg 3y agoNoted. Thanks again.