3 ms·
I have a long history of woes with this stuff. I initially had a Wanhao that didn't have ABL, that worked fine as long as I didn't change anything. Then, I got
by stavros 3y ago
I have a long history of woes with this stuff. I initially had a Wanhao that didn't have ABL, that worked fine as long as I didn't change anything. Then, I got a BLTouch, which made it worse because the Z distance would always be inconsistent somehow.
I realized that Marlin must have some sort of bug, because it claimed to be able to print on tilted beds with ABL, but mine just didn't. I upgraded to Marlin 2.x and that was fixed.
However, now I have this problem where the print lifts on certain regions of the bed. I have no idea what's up with that, I use one of those golden, textured PEI sheets and it works fine, except for these holes in areas.
I wish someone would put a pressure sensor on the nozzle so it would always know the exact distance in real time and could compensate for anything, but we seem to be far from that.
- Symbiote 3y ago> However, now I have this problem where the print lifts on certain regions of the bed If it's the edges of wide, flat prints, search for problems with "warping". Draughts and uneven heating can cause it, especially combined with poor adhesion to the bed.
- stavros 3y agoIt's not, it's a very odd issue in the middle of laying down a layer line, where a tiny mm raises/blisters, then in the next layer the raised part gets a bit longer, then a bit longer, until it becomes a big hole within twenty layers of this. It's very odd.
- Baeocystin 3y agoI had a similar problem with my old Rostock Max, and it turned out to be integer math errors in the delta>cartesian conversion step. FWIW.