4 ms·
CD drive speeds were written like 48/8/8, which stands for 48x for reading, 8x for writing CD-Rs, and 8x for re-writing CD-RWs.
by murkt 3y ago
CD drive speeds were written like 48/8/8, which stands for 48x for reading, 8x for writing CD-Rs, and 8x for re-writing CD-RWs.
- zdragnar 3y agoI'd always assumed that was due to differences in power levels needed for reading versus writing, and because writing onto disc is more error prone at higher speeds. Not necessarily anything to do with a difference in the algorithm for encoding versus decoding the bits on the disc itself.
- londons_explore 3y agoIndeed - a write must be done as one continuous action, whereas a read can be redone if error correction fails for some reason.
- bzzzt 3y agoIt's more to do with the speed of writing. While the last generations of CD writers got '48x' speeds the quality of the media is less when written at such a high speed. I remember a C!T magazine test years ago where they stated everything written at above 8x speeds would sooner develop reading errors. Maybe it's better now but I wouldn't count on it since investments in optical drives are practically zero these years.
- therealpygon 3y agoAs best as I understand it, we can start with thinking about it in terms of a music vinyl disc. For the sake of ease, let’s say that a vinyl is 60 rpm, or one revolution every second to “read” the song. (It’s actually about half that.) This is somewhat similar to how a “music cd” works and is why you can only get around 70-80 minutes of music on a CD that can hold hours of that same music in a compressed data format. The audio is uncompressed, therefore much like a vinyl. This establishes our 1x speed, in this case using one revolution per second. Now to the speed differences. To read, the laser needs only to see a reflection (or not) at a specific point, while to write, the laser needs time to heat up that same point. It’s like the difference between seeing a laser reflect off a balloon, versus the time required for that same laser to pop it. This heating is how CDs are written, quite literally by heating up points on the disc until they are no longer reflective. That’s why it is called “burning”. While more power might speed up the process, there is still time required. Meanwhile, all that is needed to read faster is an increase in the speed to observe, or the frequency to “read”, the light reflection. With more powerful lasers operating at a faster frequency and with more precision, we can have a laser “see” these differences at 48 times the normal speed, but can only burn at 8 times the normal speed before the reliability of the process suffers. Bonus: for a rewritable disc, it works slightly different. Instead of destructively burning the CD, you can think of it as being a material that becomes non-reflective at one temperature, and reflective again at another. This allows data to be “erased”. Also, when you “close” a disc to prevent rewriting, you aren’t actually preventing it from being rewritten. It is more like using a sharpie to put a name on the disc, with the words “do not overwrite” that all drive software/firmware respects.
- slenk 3y agoYes, but WHY can it only write at 8x?