9 ms·
The brittleness doesn't matter if the wire is supported to where the solder ends. I don't let it wick up much - I introduce the solder at the cut end, just enou
by WalterBright 3y ago
The brittleness doesn't matter if the wire is supported to where the solder ends. I don't let it wick up much - I introduce the solder at the cut end, just enough to solder the joint.
I have electronic equipment in nearly continuous use for 40 years. Daily heat/cool cycling. No solder breaks in it.
It seems that this debate is an old one:
https://www.linkedin.com/advice/0/what-pros-cons-soldering-vs-crimping-wires https://www.linkedin.com/advice/0/what-pros-cons-soldering-v...
https://blog.peigenesis.com/soldering-vs-crimping-advantages-disadvantages https://blog.peigenesis.com/soldering-vs-crimping-advantages...
https://www.sig4cai.com/soldering-or-crimping-which-is-better-for-your-electrical-needs/ https://www.sig4cai.com/soldering-or-crimping-which-is-bette...
P.S. I'm pretty good with soldering, since I've done it professionally, so the disadvantages of a poorly soldered joint don't apply.