2 ms·
With a traditional dedicated receiver setup, you can reduce the price floor if you go with used equipment. Speakers that haven't been abused continue to work fo
by toast0 3y ago
With a traditional dedicated receiver setup, you can reduce the price floor if you go with used equipment. Speakers that haven't been abused continue to work for decades. Receivers are less bullet proof, so it helps if you can test/demo the equipment before you buy it. But there's several recent tiers of obsolescence that mean you can likely get a bargain on quality early equipment from someone who upgraded. Pre-HDMI surround receivers with coax/optical SPDIF is still a pretty good baseline, IMHO. Depending on your sources, you might be ok with an HDMI receiver won't pass 4K, or will only pass some flavors of 4k. If your TV and your receiver support ARC, you can cable higher resolution sources direct to the TV, and then pass audio to the receiver from the TV; with ARC that gets you Dolby Digital Plus which isn't available via SPDIF, with eARC (if supported), that gets you full fidelity audio. A few sources have separate HDMI outputs for audio, but that seems pretty rare / mostly for higher end devices, in which case you're likely not skimping on a receiver.
- tomatocracy 3y agoIf you go with a receiver which will do Atmos/TrueHD etc but won't pass 4K (or won't pass newer formats eg Dolby Vision/HDR10+/etc) then the easiest route is to go with a splitter which allows you to send the audio to the receiver separately. You need to be careful to get one which won't downgrade the signal to "lowest common denominator". You can also find splitters which will will convert ARC/eARC audio into a standard HDMI signal if you have a TV which supports ARC/eARC but your receiver doesn't. The only real downside of this is you won't see any OSD information from the receiver when using the splitter.
- toast0 3y agoA splitter would also help if your source can decode TrueHD/DTS-MasterAudio, your receiver can accept multichannel PCM (I think most can?), and pass through / eARC isn't an option. No OSD is unfortunate, but certainly usable. You'll miss out on volume and source indicators if you can't see the receiver's screen, but you can connect a cable for receiver menus, and usually once you get things setup, you don't need to spend much time in receiver menus.