4 ms·
Many good reasons below - but another one is that framing large rooms is (was) expensive until pretty close to modern times with laminated beams, etc. So you'd
by bombcar 3y ago
Many good reasons below - but another one is that framing large rooms is (was) expensive until pretty close to modern times with laminated beams, etc. So you'd want to make as many smaller rooms as you could already just for cost reasons, and so making everything a separate room followed pretty closely.
Now, for the poorer people (majority?) they'd have similar sized rooms, just fewer - and the kitchen would often double as a dining room (and the living room might double as a formal dining room, if present).
I find I much prefer "openable concept" than open concept - large sliding doors to the kitchen, perhaps, or a drop down under a hutch onto a breakfast bar, so you can close the kitchen off from the rest of the house if you want.
- prawn 3y agoAlso easier to heat or cool smaller spaces. In the case of a kitchen, you can isolate and exhaust heat.
- mantas 3y agoIn my parts of the world it was the opposite. Kitchen and living room was traditionally joint. To use kitchen heat in winter to heat up the living area. Usually people would also sleep in the same room during winter.
- bombcar 3y agoThere were much more region variations on house styles before HVAC conquered everything and Nate it irrelevant. Modern energy saving building is often reverting to pre-A/C designs - of which one of the tricks is various rooms of various sizes for different times of the day.
- mantas 3y agoI doubt bigger rooms was hard to build. Here in north-east Europe traditional wooden houses were essentially 2 big rooms on either side. With entrance and storage in the middle. One side was kitchen and living room while the other was „cold“ and usually not used much during the winter.
- bombcar 3y agoIt depends on the era and the local supply - if you’re building your own house out of your own logs you can likely source quite long trees - in a pine forest. If you’re going stickbuild at the turn of the century, getting large beams from the sawmill would still be costly. Especially over 20/30 feet.