3 ms·
At 10mbps half duplex, the protocol is nearly the same. Just twisted pair uses differential pair signalling and and coax uses a shared ground and high or low on
by toast0 3y ago
At 10mbps half duplex, the protocol is nearly the same. Just twisted pair uses differential pair signalling and and coax uses a shared ground and high or low on the center conductor relative to the shield (IIRC). And twisted pair relies on a hub to create a bus. From there you go to 10M/full duplex where the rx and tx pairs are fully separated so collision detection can be disabled.
100base-tx increased the symbol rate, added speed and duplex negotiation (layered into the existing link pulse signaling), but otherwise kept things the same; you can even run a 100base-tx hub.
1000Base-T is a wide departure at the signalling level; all 4 pairs are used simultaneously, bidirectionally, the symbol rate is the same as 100base-tx, but each symbol carries more bits. But the ethernet frames are pretty much the same. (Larger frames started appearing around the same time as gigE, as I recall, but that might not be accurate)