3 ms·
> The Harrier uses fairly conventional bending nozzles to vector trust, and uses fairly conventional control surfaces at speed. On the Harrier, those are the
by Animats 4y ago
> The Harrier uses fairly conventional bending nozzles to vector trust, and uses fairly conventional control surfaces at speed.
On the Harrier, those are the big rotating lift nozzles. There are also small attitude control nozzles ("puffers") at the nose, tail, and wingtips. The puffers are used in hover and at very low speed.
This new drone is pumping out supersonic air through control jets and bending the jets with a fluidic amplifier. That's new. May or may not be useful.
[1] https://i.imgur.com/78bVjbC.png https://i.imgur.com/78bVjbC.png
- ianburrell 4y agoThese aren’t maneuvering thrusters where thrust moves the plane. These are changing the airflow on wing to act like control surfaces. Pilot should fly them the same way as now, with computers making them work and act like normal surfaces. This isn’t replacing aileron with thruster but replacing with inverse aileron. The next generation might use airflow control surfaces.
- Animats 4y agoRight. It's a fluidic amplifier. Steering a fluid jet with a smaller fluid jet is known, but not used much.
- carabiner 4y agoIt's useful for reducing radar cross section. Moving control surfaces are a headache for RCS management. The F-22 uses "cat eye" slits between its control surfaces to minimize these radar blooms, but it'd better to do away with them altogether. It could also remove the need for those huge aerodynamic fairings on the CS actuators on jetliners, but then add some complexity and remove fuel volume in the wings.