Yep, I actually ordered that exact same textured sheet you linked, and it got delivered a couple weeks ago, but I am yet to try it. I still want to make PETG wo

Yep, I actually ordered that exact same textured sheet you linked, and it got delivered a couple weeks ago, but I am yet to try it. I still want to make PETG work for me, as the prints i actually managed to finish with it were great. > While I'm waiting for the printer to reach temperature and the print to start, I make sure to remove any filament that might be dribbling out the nozzle using pliers or a wire brush until either the print starts or the nozzle pressure decreases enough for the oozing to stop. Yeeeeppp, been doing that exact same thing, and it was working quite well. But not going to lie, I felt a bit destroyed on the inside when I still got the nozzle clogging issue about 10 hours into a 16hr print I had going. I wrote it off as a one-off, but I have been hesitant to try another 16hr-long print with PETG since then (until i at least get the textured sheet set up). Thanks for your comments in this thread btw, they definitely highlighted quite a lot of issues I had and potential workarounds.