4 ms·
Indeed. I always figured that even if the cost to manufacture has gone down for any given piece of electronics that cost to society has actually gone up because
by jacquesm 4y ago
Indeed. I always figured that even if the cost to manufacture has gone down for any given piece of electronics that cost to society has actually gone up because instead of repairing things (which also provided jobs) they are now discarded far earlier than they would have been in the past.
Much earlier in my life I earned some money on the side repairing electronics and while it is of course still technically feasible the number of one-off components in any given device is so high and the documentation and repairability so low that it just isn't worth it. This was not a good development, but it seems we're stuck with it. The one big plus from all this integration is that devices consume far less power than they used to.
- judge2020 4y agoIt's like cars. Decades ago you might see your local mechanic once a year (if you're lucky) or multiple times a year to fix issues with the car, nowadays there's a good chance a new car will go 100k miles with only wear-and-tear items needing maintenance done.
- jacquesm 4y agoBut if they break you're in for a world of trouble, and you will in one go end up offsetting a good chunk (or more) of what you saved up to that point. In a way this is the result of designing things to outlast their warranty, once the warranty period is over anything that still works was essentially overdesigned. Fortunately for cars and other high ticket items the secondary market will punish brands that are playing it too loose and too fast but I've seen pricing for for instance headlight or taillight assemblies that make you wonder if there is an error.
- ecpottinger 4y agoMy mom's fridge broke exactly one day after the warranty expired. She was crying on the phone, then they said they would honour the repair anyway. That made her happy again.
- Zach_the_Lizard 4y agoOld cars had more maintenance requirements and were far less reliable, but repairs tended to be simpler. For example, you may need to tune your carburetor seasonally. Old points based distributors needed the points adjusted or replaced. Simple tools like a screwdriver and a matchbook can get those two sorted. Fuel injection and electronic ignition eliminated a lot of regular maintenance, but they are harder for the average person to troubleshoot, let alone repair. Gone are the days where a rough idle could be fixed with a screwdriver. But so too are the days where a mountain pass requires that same screwdriver to be pulled out on the way up and the way down to adjust the fuel-air ratio.
- 13of40 4y agoI have a car maintenance manual from very early in the 20th century (1910 or something) and the maintenance schedule it describes would be ludicrous nowadays. It talks about changing the oil and greasing all of the joints every couple hundred miles, for example. At the same time, there are some components that are essentially the same now. Based on the diagrams, it looks like the wheel hubs and bearings would be compatible with the ones on my modern boat trailer.
- lostlogin 4y agoThe bearing might be compatible, but new ones are so much better. The slop (if that’s the right word) in bearings manufactured 50 years ago was more than you get now.
- 13of40 4y agoI'm not a serious mechanic, but I suspect one of the reasons the bearings and shaft on the hub are tapered is so you can tighten it down and accommodate for minor variations in the tolerances. That would have been more important before it was all being done with CNC. The material for the bearings was probably not super either.
- jacquesm 4y ago