3 ms·
You probably don't hear much from people who are happy with their heat pumps, because it's boring when it just works. But, the competence required for heat pum
by toast0 4y ago
You probably don't hear much from people who are happy with their heat pumps, because it's boring when it just works.
But, the competence required for heat pump sizing depends on the local climate. If you need more heat than the outside unit can gather, you're stuck with fallback heat, which is usually resistance strips, which is expensive. Some thermostats will call for the fallback heat anytime the requested temperature is 2-3 degrees F above the measured indoor temperature; if you've got a thermostat like that, you've got to be careful how you adjust it, and HVAC installers don't always explain that in ways that the users understand. Lots of people want it a few degrees colder when they're sleeping, but setting that up in the most straightforward way leads to resistance heating in the morning.
You're going to tend to want to windows of conditioned spaces closed, otherwise you're sending your heating budget out of the windows. Heat pumps are usually setup so you can directly regulate the temperature as desired, rather than boilers where it gets so hot that you need to open the windows to balance. If you want to run it with the windows open, you'd need more capacity, and you'd really need to convince your HVAC person. It probably makes more sense to look into a heat recovery ventilation system, which gets fresh air in without losing as much of the heat (or gaining as much heat if you're cooling). This is probably a norms thing.
Insulation helps reduce heating / cooling costs for sure, but if your home is less insulated than the norm, you just need a larger capacity system. That's another place where installer competence comes in. Actually measuring airflow and calculating requirements is unfortunately not very standard, there's a lot of rules of thumb or replacing with similar size units or the neighbor has X so use that. Again, this is workable in mild climates, but if you've got outside temperatures much below freezing, you need a competent installer, as capacity goes down quite a bit as the temperatures go down, and that's also when you need it the most. And, just insulating the heck out of an old home that was built to be drafty can cause issues with retained moisture and mold; it needs to be done carefully and appropriately.
- fauigerzigerk 4y agoSo the fallback heat issue seems fixable by learning how to operate the equipment properly. That's good to know. Unfortunately, the requirement to keep windows shut and install a ventilation system instead rules out every single place I have ever lived in.
- toast0 4y agoYeah, if you're accustomed to keeping windows open during the heating season, I think you're going to have a bad time unless you live with a mild climate. Sounds like you're probably on a boiler / radiator system; which probably means you're not in a very mild climate. You could ask an HVAC company what it would take to be on a heat pump with the windows open, but it's probably going to cost a lot of electricity, and if you build the system for that, when you eventually do decide to close the windows, the system is going to be too big and you'll have comfort issues from that. Do you have air conditioning? Do you leave the windows open during the cooling season?
- fauigerzigerk 4y agoUnderstood, thanks! I'm in London using a gas boiler like almost everybody here. Our windows are always open in the summer and also during much of spring and autumn to keep the mold at bay and the air fresh.