3 ms·
I make repairs to cables like these with a very simple method: glue the two pieces together with superglue and some overlap, a few mm will do. Then use conducti
by jacquesm 4y ago
I make repairs to cables like these with a very simple method: glue the two pieces together with superglue and some overlap, a few mm will do. Then use conducting glue (with silver particles in it) to restore the connection. Use a tiny brush and a microscope to apply the glue. If the currents are low (as they usually are with cables like these) this will work just fine and give a quick and long lasting result.
- arthurcolle 4y agoHaha I can picture you with your glue gun diligently applying layers
- jacquesm 4y agoWith your last name it is I that can imagine you diligently applying layers with your glue gun ;) Anyway, I use a tiny brush, but you have to be careful not to make shorts.
- gus_massa 4y agoCan you post some photos? [Just to be clear, it's not a "pics or it didn't happen". I believe you, but I'd like some photos.]
- jacquesm 4y agoNext time I do one, sure. The stuff I use is meant to repair rear window defrosters, Loctite 3863.
- arcticbull 4y agoThe cleanest way DIY way I've seen is the way TCRS handles flexgate ribbon repairs. [1] Cut both cables. Scrape the coating. Tin the copper on both sides. Slightly overlap both cables. Tack them down, and create a solder bridge. [1 around minute 25]. Span the gap with small wire [1 around minute 29]. Finish up with conformal coating [1 around minute 57]. [1] https://www.youtube.com/watch?v=OGKucaMJEAc https://www.youtube.com/watch?v=OGKucaMJEAc
- jacquesm 4y agoInteresting, I've tried it that way a couple of times but the thermal stability of the cable is so low that I ended up melting the carrier. That's why I've switched to a 'cold' method.