2 ms·
This probably was caused by poor design of the charger. For a huge overcurrent event to happen, some of the switching elements in the power converter failed (o
by londons_explore 4y ago
This probably was caused by poor design of the charger.
For a huge overcurrent event to happen, some of the switching elements in the power converter failed (or their control logic did).
However, that is a reasonably foreseeable event. The charger should have been tested for what happens when each piece of the charger fails open circuit or short circuit.
It is perfectly possible to design control electronics which can detect the failure of any piece and adjust the control strategy of the other parts of the circuit to prevent damage to whatever is on the output.
- londons_explore 4y agoThis is the circuit used in most DC fast chargers: https://www.researchgate.net/publication/261875419/figure/fig4/AS:668856804704263@1536479297576/The-dc-fast-charging-circuit.png https://www.researchgate.net/publication/261875419/figure/fi... If any of the 6 transistors on the left fail, you simply turn off all of the other 5, and your car is safe. If the bottom right transistor fails short, you will get an overcurrent event in the top right transistor, and must turn it off before it blows up - which will typically need to be done in nanoseconds. If the bottom right transistor fails open, the top right transistor will blow up unless you have a backup body diode across the bottom right transistor. If the top right transistor fails open, nothing bad happens. If the top right transistor fails short, you need to immediately turn on all the other transistors, and deliberately blow a fuse on the AC input (this will be destructive - every transistor will fail most probably).