3 ms·

not really. we used to sell them, but its a bit fussy. people had quite legitimate concerns about what to do when the modules went. margins are good, but not as

not really. we used to sell them, but its a bit fussy. people had quite legitimate concerns about what to do when the modules went. margins are good, but not as high as fine art, and the labor is about the same for us. since our primary activity is metal sculpture....we really don't have to deal with cooling issues. 10-20 pounds of metal, even steel, makes a _really good_ heat sink, even if it is isn't optimized for maximum convection. and now your light elements are little 3cm circles a couple mm high, and you can tuck them wherever you want. it wouldn't be too hard to make you own standard. the constant current drivers often have pretty wide input ranges, especially if you can stick with simple bucks. the part where I really kinda fell down was connectors oddly enough. 3 pins, moderate current, few cycles, low cost, high contact reliabilty. anyone with better connector-fu than me have a suggestion?

the_pwner224 4y ago
Just saw this other comment here. https://news.ycombinator.com/item?id=35013509 https://news.ycombinator.com/item?id=35013509 USB-C might work. USB PD supports 5a at up to 20v, looks like there's also a higher power 50v 5a spec coming up. But if you're using custom PCBs on both ends you don't really care about the PD specification, as long as you're using good quality cables you can treat the connector/cable as a dumb wire that supports sending 5 amps down a few pins. The data lines may also be useful for sending back data from the emitter module, if you had any need for that. Desktop computers use the Molex Mini-Fit Jr connector for ATX and PCIe power connectors. 6-pin PCIe power cables should be easy to source on the market, you wouldn't need to get custom cables manufactured. Those can carry ~150w. Might also be possible to cheaply source cables with just a 2 or 4 pin connector?
aidenn0 4y ago
3 single Anderson Powerpole connectors (they are designed to slide together, and a drop of CA glue can make the connection permanent). Available up to 45A

the_pwner224 4y ago

Just saw this other comment here. https://news.ycombinator.com/item?id=35013509 https://news.ycombinator.com/item?id=35013509 USB-C might work. USB PD supports 5a at up to 20v, looks like there's also a higher power 50v 5a spec coming up. But if you're using custom PCBs on both ends you don't really care about the PD specification, as long as you're using good quality cables you can treat the connector/cable as a dumb wire that supports sending 5 amps down a few pins. The data lines may also be useful for sending back data from the emitter module, if you had any need for that. Desktop computers use the Molex Mini-Fit Jr connector for ATX and PCIe power connectors. 6-pin PCIe power cables should be easy to source on the market, you wouldn't need to get custom cables manufactured. Those can carry ~150w. Might also be possible to cheaply source cables with just a 2 or 4 pin connector?

aidenn0 4y ago

3 single Anderson Powerpole connectors (they are designed to slide together, and a drop of CA glue can make the connection permanent). Available up to 45A