3 ms·
backwards compatibility: https://en.wikipedia.org/wiki/36-bit_computing#History https://en.wikipedia.org/wiki/36-bit_computing#History cf https://datatracker.i
by 082349872349872 4y ago
backwards compatibility: https://en.wikipedia.org/wiki/36-bit_computing#History https://en.wikipedia.org/wiki/36-bit_computing#History
cf https://datatracker.ietf.org/doc/html/rfc4042 https://datatracker.ietf.org/doc/html/rfc4042 (note date)
- DougMerritt 4y agoI'm asking about the original thinking, not about later backward compatibility.
- greenyoda 4y agoThe Wikipedia article cited above has some practical reasons: > Early binary computers aimed at the same market therefore often used a 36-bit word length. This was long enough to represent positive and negative integers to an accuracy of ten decimal digits (35 bits would have been the minimum). It also allowed the storage of six alphanumeric characters encoded in a six-bit character code.
- DougMerritt 4y agoCoincidentally I commented on this above at the same time you were posting -- thanks.
- DougMerritt 4y agoYour link does say: "Early binary computers aimed at the same market therefore often used a 36-bit word length. This was long enough to represent positive and negative integers to an accuracy of ten decimal digits (35 bits would have been the minimum). It also allowed the storage of six alphanumeric characters encoded in a six-bit character code." Which helps a little, but it still begs the question: why ten decimal digits? Why not nine or eleven or something? Are they implying that six characters of six bits was the critical issue? If so, why not seven characters? Or five? Etc.
- tgv 4y agoSix character is (in)famously the maximum length of linker symbols on IBM systems, at least for FORTRAN. Perhaps that had something to do with it. And of course, there comes a time when you have to pick a number, so why no 6x6, which is also good for 10^10 integers?
- vincent-manis 4y ago6 was the magic number on 700/7000 systems. With System/360, the magic number grew by 1/3, to the magnificent total of 8.
- lapsed_lisper 4y agoIf you're keen to go down the wikipedia hole, https://en.wikipedia.org/wiki/Six-bit_character_code https://en.wikipedia.org/wiki/Six-bit_character_code and then https://en.wikipedia.org/wiki/BCD_(character_encoding) https://en.wikipedia.org/wiki/BCD_(character_encoding) explain that IBM created a 6-bit card punch encoding for alphanumeric data in 1928, that this code was adopted by other manufacturers, and that IBM's early electronic computers' word sizes were based on that code. (Hazarding a guess, but perhaps to take advantage of existing manufacturing processes for card-handling hardware, or for compatibility with customers existing card handling equipment, teletypes, etc.) So backward compatibility is likely the most historically accurate answer. Fewer bits wouldn't have been compatible, more bits might not have been usable! (Why 6 bit codes for punch cards in 1928? Dunno. Perhaps merely the physical properties of paper cards and the hardware for reading them. This article talks about that stuff: https://web.archive.org/web/20120511034402/http://www.ieeeghn.org/wiki/index.php/STARS%3APunched_Card_Equipment https://web.archive.org/web/20120511034402/http://www.ieeegh...)
- DougMerritt 4y agoIIRC I think six characters was also the maximum for the length of global symbols in C on early Unix systems, possibly just because that's what everyone was used to on earlier systems. But note that I asked about why six characters, not why six bits per character -- however your note is perhaps suggestive -- maybe the six character limit is similar to the six bit character after all: something established (possibly for mechanical reasons) in 1928? Perhaps?