4 ms·
An old Amiga with ‘Titanic’ miniature shoot ‘video taps’
- progman32 4y agoThe title is a bit more understandable with original punctuation: An old Amiga with ‘Titanic’ miniature shoot ‘video taps’ on it is a treasure-trove of VFX history
- Gordonjcp 4y agoI think they might also have typoed "tapes".
- plastic3169 4y agoVideo tap is a video camera that is connected to film camera viewfinder so that crew can view material on a monitor and also record preview quality image (the video taps)
- moosedev 4y agoI'm guessing it's derived from plumbing jargon[0], in the sense of inserting an access point into an existing system to gain access to the resource inside; this idea is also found metaphorically in the common phrasal verb "tap into"[1] (make use of or gain advantage from an existing resource). [0] https://www.mcwaneductile.com/blog/what-are-the-three-pipe-tapping-methods https://www.mcwaneductile.com/blog/what-are-the-three-pipe-t... [1] https://dictionary.cambridge.org/us/dictionary/english/tap-into https://dictionary.cambridge.org/us/dictionary/english/tap-i...
- wildzzz 4y agoThey are sometimes called taps in the RF industry. It's for when you want have a monitor port for a signal without disrupting the original signal too much. You'll still lose a little bit of power on the original signal but this will only be as much as 3dB for a splitter (where both outputs are equal in power) or much less for something like a 15dB coupler (the monitor signal is 15dB less than the original output). Since it's impossible to measure an RF signal without stealing at least little bit of power, there is always just a little bit of loss on the original signal. There are similar devices for fiber optics where they bond a fiber to the original so some light escapes the original fiber and goes into the second bonded fiber. This can even be done in the field on in-use lines where a tap fiber is wrapped tightly around the main fiber and bonded with a torch. You can even tap a fiber line by just bending it enough and placing a detector at the bend since some light will escape there. Something similar can be done for light where a diagonal piece of glass sits in front of one camera and another camera sits 90deg pointed at the same glass. Some light gets through the glass but most reflects so one camera sees a slightly darker image and the other sees a much darker image.
- yawpitch 4y agoIt’s etymologically from the notion of tapping a keg or barrel… you literally had to tap (hammer) a tap (cone-shaped cork, bung, or — eventually, but much later - a plumbed faucet or tap) into a vessel to access the contents. Technically the video tap is the beam splitter and associated mounting affordances and hardware that redirects light bouncing off the mirror shutter to both the operator’s viewfinder and to the video assist camera; you could mount a 100% tap, replacing the viewfinder entirely, or various degrees of partial beam splitter. In either case the tap allowed you to capture video footage of what the camera operator was seeing… which, confusingly, was exactly what did NOT actually end up in the final film, since both the viewfinder and assist can only receive light when the shutter is closed and the film is moving to the next frame.
- moosedev 4y agoOf course, I forgot about kegs/barrels. I can well believe that that's the older etymology. Thanks!
- Gordonjcp 4y agoAh, we call that "video assist" here.
- yawpitch 4y agoTo be accurate the video tap is the hardware assembly that allows video signal to be recorded at the same time as the film is being exposed — or very nearly the same time, since the film can’t be exposed while the video camera is receiving light — and video assist is the production technique of using that tapped video to aid production work (VFX, editorial, cinematography, playback, continuity, etc) while the exposed film awaits processing and scanning. In other words you needed a video tap to allow for video assist.
- dylan604 4y agoIt's also the name of a connection when you have a single video signal sent to a distribution amplifier so that it becomes a 1-to-many signal. Each of the output connections is referred to as a tap.
- gbraad 4y agoVideo tap here refers to the direct video feed that went into the VideoToaster to allow quick previewing. Something that was otherwise hard to do. This is still the time of (analog) filmreel use.
- pimlottc 4y agoA bit, but without knowing what “video taps” means, it’s still pretty unclear
- ManuelKiessling 4y agoTangential: has anyone watched the 4K/3D/HFR remake? Is it any good?
- nebula8804 4y agoYes there is nothing wrong with it. Almost looks like a new movie released in 2023. However it is a re-release of an old film so if your not keen on watching an old film then there isn't a point. Keep in mind in the US they are showing the 2.39:1 AR Scope version. In 2012 when they did the remaster, they supposedly showed the better 1.78:1 version so thats a bummer seeing the original 2.39:1 version and not the version that Cameron (I think) prefers. However, this time around you get HDR and HFR (in addition to the 4K and 3D you got in 2012) so thats nice. On the downside, when I went to see it, the HFR scenes were very limited and oddly chosen seconds here and there so i'm not sure if it adds anything. Frankly I feel the same about the 3D. While this film is a pretty good implementation of the technology, was anyone really asking to add 3D to this movie? I missed the 2012 remaster for the 100th anniversary of the sinking. I feel fortunate to see it in theaters this time for the film's 25th anniversary. For the record I have seen in AMC's Dolby 3D and Cinemark's XD implementations. I think they both use dual laser projection. I have skipped the standard 2K version.
- dylan604 4y agoThere's a lot of opinion in this: "they supposedly showed the better 1.78:1" By creating the 1.78, there is picture that has been cropped out and is no longer visible. The director/DP shot it in the original aspect for a reason. To create the non-OAR version, compromises were made. To say that the cropped version is better is a heavy bit of opinion to say the least. "However it is a re-release of an old film so if your not keen on watching an old film then there isn't a point." Wow, just so much wow. Yes, let's never watch a movie because it is older. That's like saying, never read a book that wasn't released in the past couple of years. You're cutting out a large percentage of material based on some very strange criteria.
- smackeyacky 4y ago
- dmix 4y agoIt seems to be miniatures of the two submarines at the beginning of the movie Starting at 1:20 you can see the real thing here: https://youtu.be/PcuKfOomVbM https://youtu.be/PcuKfOomVbM I'm guessing these miniature submarine shots were overlaid on top of real shots of the titanic? And then VFX were added to make the subs look cooler. Spliced with other shots to make it look like the scientists were inside the subs. The YT comment was even more interesting than the clip
- kaycebasques 4y agoIt seems that the HN community has a soft spot for submissions with the word "trove" in the title. This is the third or fourth one on the front page this week...
- unwind 4y agoThank you, I was starting to wonder if there was a secret game going on, or if I was supposed to screenshot them all and post for a hat-trick or whatever. So strange. Not sure if I was being hit by Extra Strong(tm) confirmation bias [1], so at least very nice to see I was not alone in reacting. [1]: https://en.wikipedia.org/wiki/Confirmation_bias https://en.wikipedia.org/wiki/Confirmation_bias
- DoctorOW 4y agoIIRC the HN algorithm checks for patterns in titles of articles people are interested in in.
- actionfromafar 4y agoSee also, high correlation between having trove in the title and actually containing a trove of something.
- albert_e 4y agoThe actual footage is shown with a blue overlay on all 4 sides and an yellow border-- am I missing something? Is that how the original is?
- bathtub365 4y agoThe video signal is 4:3 aspect ratio and the blue is the area cropped out to result in the frame you’ll see on film
- hota_mazi 4y agoIf you actually read the article, it has nothing to do with the Titanic. One person who worked on Titanic explains where these shots came from and how they landed there (they were for True Lies, and he and a bunch of friends were Amiga fans who convinced the team to use Amigas instead of the $60k equipment they were using).
- pavlov 4y agoThis Amiga-based playback system was introduced during the production of True Lies, but they continued using it during Titanic.
- snozolli 4y agoIt's literally in the first paragraph: The Commodore Amiga 4000/040 was used by Digital Domain to help craft effects shots and review miniature shoots for Titanic, Apollo 13 and True Lies. The video shows footage of miniatures for Titanic. True Lies and Apollo 13 didn't have footage of a model of The Titanic.
- sgt 4y agoThis guy should be on HN to tell some stories :) https://www.linkedin.com/in/jonathan-egstad-7113002/details/experience/ https://www.linkedin.com/in/jonathan-egstad-7113002/details/...
- monkeynotes 4y agoAnd elucidate laymen on what all the jargon means. Still don't know what a PAR is :)
- kabr 4y agoPersonal Animation Recorder — an add on card for the Amiga that stores and plays back frames. http://amiga.resource.cx/exp/par http://amiga.resource.cx/exp/par