2 ms·
I doubt you'd even need to get a new controller. If the wording in the article about what breaks -- just the port itself -- is accurate, the ports themselves c
by kelnos 4y ago
I doubt you'd even need to get a new controller. If the wording in the article about what breaks -- just the port itself -- is accurate, the ports themselves cost a few bucks on a site like DigiKey, and even if you have no experience soldering, you could fix it, working very slowly, carefully, and methodically, over a few hours. (Someone with experience could do it much faster, of course).
Sure, I get that you might be squeamish about opening up a $16,000 device yourself and taking a soldering iron to it, but a port/connector is about as low risk as it gets when you need to repair electronics.
If you don't have a decent soldering iron or any of the related accessories, this "$3k" repair will cost under $100. If you do have one, it will cost you under $10.
- ComputerGuru 4y agoI was being charitable and assuming absolute worst case scenario. But I agree.
- BizarroLand 4y agoAnother fun thing (that I or someone I know might have done) is when you do a great job replacing the port with an exact replica but in the process somehow manage to desolder a resistor that's about the size of a small shard of a grain of rice from the board AND simultaneously knock the board so that the resistor goes flying into your carpet so now even though everything else is good the system won't work because you don't have the tools or know-how to locate a replacement.
- ComputerGuru 4y agoHeh heh been there, done that. Was reflashing the eeprom on a $800 raid card and sheared off two surface mount resistors while pushing the card back in the slot. That horrible sinking feeling when you already know without checking that you’ve screwed up big time!
- II2II 4y agoI wouldn't suggest a simple fix on an expensive device as a first soldering project. It is not that you need much experience, but it is risky and a little experience removes virtually all of the risk. Either practice on a few throw away boards with a similar part first, or ask someone you know who has relevant experience to do it for you.
- Tempest1981 4y agoI've had mixed results -- occasionally lifting traces/pads. Does that mean my iron is too hot? Seems like some boards are more delicate than others.