4 ms·
It should easily be possible to add a handle to it though. Could be either 3d printed or even hand carved from a big stick or something. Maybe it should be poss
by WJW 4y ago
It should easily be possible to add a handle to it though. Could be either 3d printed or even hand carved from a big stick or something. Maybe it should be possible to route much of the cabling through the handle as well? Hmmmm.
- Y_Y 4y agoI wouldn't trust any 3d printed filament for any serious hammering tasks. Assuming you have the strength to heft it, I'd go with thick old-growth oak screwed directly into the motherboard. A steel handle might offer better heat dissipation but falls down on aesthetic and battle-comfort grounds.
- tomrod 4y agoHear hear! But be sure to avoid overly mossy handles as the oils built up over the years lower the heat dissipation capable via the handle and is a better electric conductor -- not a good thing if you are wanting to channel lightning at places other than yourself.
- marcus_holmes 4y agoI'd also want some serious external cable management. Serious hammering is not going to be possible with power and monitor cable flailing around.
- fanatic2pope 4y agoBuy a hickory axe handle, cut off the tenon and put in a threaded insert. Then you'd only need to drill a small hole in the top of the case to thread a bolt through to hold it on. If you want to be fancy, get a wood burning kit and burn some runes into it or something.