2 ms·
Unless you're going for sniper level accuracy a barrel can be rifled with just the button because the die will cause its own rotation as you push it down the ba
by jacquesm 4y ago
Unless you're going for sniper level accuracy a barrel can be rifled with just the button because the die will cause its own rotation as you push it down the barrel, this is because of the trailing part of the button.
The reason rifling machines do it is to ensure minimal wear on the die, and for speed of operation but that's an optimization more than a requirement. This is also the reason why the cutters on a typical button are as long as they are: to ensure that it rotates.
You also don't need to index it for the same reason: the tool will seek the grooves made by the previous pass (except for point cutters).
It's basically just a very coarse inside thread cutter, where the thread is so steep that it will drive the tool to rotate much as the bullet will rotate when passing through. This will work with any thread that is more than 1:1.