2 ms·
FYI, it isn’t actually harder to make ammo than the gun. I have a decent amount of experience reloading and machining (including machining parts that could easi
by lazide 4y ago
FYI, it isn’t actually harder to make ammo than the gun. I have a decent amount of experience reloading and machining (including machining parts that could easily be guns, but weren’t). I also have quite a bit of experience with muzzle loading/black powder, etc.
It’s just not something that is currently optimized to make in an improvised way, because ammo is normally the easy, bulk, part. It does require a decent amount of expertise, and ability to pay attention to detail though.
If someone was so motivated, metal slugs + compressed gas can make a far more than adequate weapon (semi-auto too!), and would 3D print quite nicely. If someone was going to go that way, 3D printing a suppressor would be trivial too.
And those slugs could be easily cast in any kitchen using commonly available materials (zinc, for instance, if lead was controlled).
The underlying reason this isn’t really a problem is due to motive, economics/payback, etc.
It’s solidly in the ‘but why?’ category for pretty much everyone, but if someone had a reason, I bet they could make a 3D printable design with a couple pages of directions and almost anyone could do it.
The local scuba shop would have quite the run on pony bottles though!