3 ms·
> allowing the FRC to expand again does work on the coil, sustaining its current and allowing energy to be extracted. Sure, some energy might be recoverable th
by Retric 4y ago
> allowing the FRC to expand again does work on the coil, sustaining its current and allowing energy to be extracted.
Sure, some energy might be recoverable that way but what percentage of energy is extracted and what percentage ends up as waste heat. At a minimum those neurons from DD fusion, and photons from hot plasma etc are’t being recovered. A mere 100 MW device operating at an awe inspiring 90% efficiency would still be producing a 10MW aka a fuck ton of waste heat and I doubt anything close to 90% would be theoretically possible.
Not to mention mechanical stresses etc from such detonations.
- pfdietz 4y agoNeutrons from DD fusion will carry a smaller fraction of energy that neutrons from DT fusion. They also don't need to breed tritium, and don't need to deposit their energy at high temperature (since no thermal cycle is necessary to convert that heat to power, especially in D3He-optimized reactors; the heat can just be dissipated.) This means the cooling could be simple, with water at moderate temperature and pressure. This would also shield the neutrons effectively. The heating part I'd worry about most is photons hitting the inner surface of the fusion chamber. These will be absorbed in a thin surface layer, and since the system is pulsed the instantaneous heating could be quite high. They might have to resort to a liquid layer that's ablated by the thermal pulse. This would eject gas into the chamber, but they're using a pulsed approach anyway so this could be ok, if the pulse is shorter than the time the evaporated gas needs to reach the plasma.
- Retric 4y agoSaying they don’t need to breed Tritium is yet another red flag, because their method of breeding H3 also breeds Tritium. In other words they do need to breed Tritium. Expect worse because not only do they need to breed Tritium they apparently want to separate it from their fuel and treat it as nuclear waste. PS: Anyway, to correct a mistake breeding Tritium from D doesn’t produce a neutron the reactions should roughly equal amounts of: D-D → He3 + n + 3.268 MeV D-D → T + p + 4.032 MeV D-He3 → He4 + p + 18.354 MeV (Slightly less due to escaping He3) Plus some contamination with Tritium resulting D-T → He4 + n + 17.571 MeV
- zardo 4y ago> Tritium they apparently want to separate it from their fuel and treat it as nuclear waste. Not waste, but they do want to store it for ~20 years to wait for it to decay into He3.