2 ms·
Just build a working device and I am easily convinced, except why would they care about what I think if they have that. It’s really the technical details they
by Retric 4y ago
Just build a working device and I am easily convinced, except why would they care about what I think if they have that.
It’s really the technical details they are providing actually makes them seem more like a scam, if they shared less it might seem more reasonable. But sharing a lot except any relevant numbers while suggesting it’s ready soon screams scam.
For example they need 2 DD reactions to on average produce 1 H3 which means their producing more high energy neutrons than a pure DT design for the same energy. If T is a waste product then they need to do separation etc. At the same time they are also going to have some DT reactions which means they will need basically identical radiation shielding either way.
The idea of extracting energy from magnetic field interactions sounds plausible until you consider all the waste heat that’s being produced. Even if everything worked as described they would still want massive amounts of cooling which is either a problem or another power source. If they had said they are using a mix of both that would be far more believable.
- pfdietz 4y agoThey have built six working devices. These have not achieved the end goal yet, but the results have been enough to open the money spigots for more funding. Really, what is your problem here? I get a strong Dunning-Kruger impression from your objections. You think you know more than you do. Example: your objection to recovery of energy from the magnetic field. This is not hard to understand! They increase the magnetic field to compress the FRC. This heats the particles adiabatically, just like a piston compresses a gas. And JUST LIKE A PISTON, this is a completely reversible process: allowing the FRC to expand again does work on the coil, sustaining its current and allowing energy to be extracted.
- Retric 4y ago> allowing the FRC to expand again does work on the coil, sustaining its current and allowing energy to be extracted. Sure, some energy might be recoverable that way but what percentage of energy is extracted and what percentage ends up as waste heat. At a minimum those neurons from DD fusion, and photons from hot plasma etc are’t being recovered. A mere 100 MW device operating at an awe inspiring 90% efficiency would still be producing a 10MW aka a fuck ton of waste heat and I doubt anything close to 90% would be theoretically possible. Not to mention mechanical stresses etc from such detonations.
- pfdietz 4y agoNeutrons from DD fusion will carry a smaller fraction of energy that neutrons from DT fusion. They also don't need to breed tritium, and don't need to deposit their energy at high temperature (since no thermal cycle is necessary to convert that heat to power, especially in D3He-optimized reactors; the heat can just be dissipated.) This means the cooling could be simple, with water at moderate temperature and pressure. This would also shield the neutrons effectively. The heating part I'd worry about most is photons hitting the inner surface of the fusion chamber. These will be absorbed in a thin surface layer, and since the system is pulsed the instantaneous heating could be quite high. They might have to resort to a liquid layer that's ablated by the thermal pulse. This would eject gas into the chamber, but they're using a pulsed approach anyway so this could be ok, if the pulse is shorter than the time the evaporated gas needs to reach the plasma.
- Retric 4y agoSaying they don’t need to breed Tritium is yet another red flag, because their method of breeding H3 also breeds Tritium. In other words they do need to breed Tritium. Expect worse because not only do they need to breed Tritium they apparently want to separate it from their fuel and treat it as nuclear waste. PS: Anyway, to correct a mistake breeding Tritium from D doesn’t produce a neutron the reactions should roughly equal amounts of: D-D → He3 + n + 3.268 MeV D-D → T + p + 4.032 MeV D-He3 → He4 + p + 18.354 MeV (Slightly less due to escaping He3) Plus some contamination with Tritium resulting D-T → He4 + n + 17.571 MeV
- zardo 4y ago> Tritium they apparently want to separate it from their fuel and treat it as nuclear waste. Not waste, but they do want to store it for ~20 years to wait for it to decay into He3.