Its not no soldering but it is low effort soldering. Pulling from a couple guides here. Tasmota is local first. Get a wemos D1 and a https://www.ikea.com/us/e

Its not no soldering but it is low effort soldering. Pulling from a couple guides here. Tasmota is local first. Get a wemos D1 and a https://www.ikea.com/us/en/p/vindriktning-air-quality-sensor-60515911/ https://www.ikea.com/us/en/p/vindriktning-air-quality-sensor... https://tasmota.github.io/install/ https://tasmota.github.io/install/ flash the unofficial all sensors build. https://github.com/Hypfer/esp8266-vindriktning-particle-sensor/blob/master/img/board.jpg https://github.com/Hypfer/esp8266-vindriktning-particle-sens... Solder as follows GND to GND on ESP, 5V to 5V on ESP and finally the last one to D2 on the ESP. Guides I am stealing from. https://github.com/Hypfer/esp8266-vindriktning-particle-sensor https://github.com/Hypfer/esp8266-vindriktning-particle-sens... Has most of the hardware side. But its using a different software. https://blakadder.com/vindriktning-tasmota/ https://blakadder.com/vindriktning-tasmota/ is where I got most of the rest of the info but he uses a separate voltage regulator. If you use the Wemos D1 Mini you should not need that. After that the internet has plenty of info for hooking tasmota and say home assistant together.