Molex 63811-1000, full stop. I do this professionally (automotive harness prototyping), and this is the first tool I reach for when I have open-barrel terminals

Molex 63811-1000, full stop. I do this professionally (automotive harness prototyping), and this is the first tool I reach for when I have open-barrel terminals to work with. If they have a wire-grip section longer than 2.5mm, this is your answer. That means Dupont, most styles from Molex, TE, Sumitomo, Yazaki, etc. (The second is the Iwiss IWS-2820M, for open-barrels with a short wire-grip section, 2mm or below. That's basically most JST styles. The Iwiss crimper has all the same nest sizes as the Engineer PAD-11 but is much better made, smaller, and cheaper to boot.) There are, of course, countless $300-and-up official tools for specific terminals, but as far as generics go, these two are the cream of the crop. Beware ebay triangulation scams with the 63811-1000. It should cost $55-65, any less and you're being lured. Safest to get it from one of the vendors listed on Octopart. For the Iwiss, as much as I hate to say it, just go to Amazon.