2 ms·
How Does Samsung SSD T7 Perform on Raspberry Pi
- johnklos 4y agoThis is interesting, but clearly there was caching going on, because the physical bus can't go as fast as some of these results. Samsung's own comments about their drives: To reach maximum read/write speeds of up to 1,050/1,000 MB/s, respectively, the host device and connection cables must support USB 3.2 Gen 2 and the UASP mode must be enabled. Timing cached reads: 2038 MB in 2.00 seconds = 1020.29 MB/sec Timing buffered disk reads: 874 MB in 3.00 seconds = 291.21 MB/sec Makes sense. Timing cached reads: 35130 MB in 2.00 seconds = 17596.74 MB/sec Timing buffered disk reads: 2620 MB in 3.02 seconds = 866.55 MB/sec 17 gigabytes a second? If I had to guess, the test was run more than once without flushing the (computer's memory) cache / being rebooted / being disconnected and reconnected.
- justsomehnguy 4y ago-T Perform timings of cache reads for benchmark and comparison purposes. For meaningful results, this operation should be repeated 2-3 times on an otherwise inactive system (no other active processes) with at least a couple of megabytes of free memory. *This displays the speed of reading directly from the Linux buffer cache without disk access. This measurement is essentially an indication of the throughput of the processor, cache, and memory of the system under test*.
- Havoc 4y agoI did similar for my k3s rasp cluster - makes a big difference in perceived speed of the raspberry pis. It’s a pretty cheap upgrade at 30-40 bucks A lot of cheap USB adapters give issues though. Ended up disabling UASP mode on mine due to severe stability issues
- ilyt 4y agoPlease use FIO, that way of doing benchmark is hard to get right here is example config https://github.com/XANi/toolbox/blob/master/benchmark/io/config.fio https://github.com/XANi/toolbox/blob/master/benchmark/io/con...