2 ms·
Oww, come on, there is no way it could have been vertical, and even if it was, it would be way too short, given the diameter, to allow for a meaningful air cush
by jaclaz 4y ago
Oww, come on, there is no way it could have been vertical, and even if it was, it would be way too short, given the diameter, to allow for a meaningful air cushion.
Besides, in actual hammer arrestors both inlet and outlets would have been at the very bottom.
- cryptonector 4y agoFair. Then what's the point of that tank?
- jaclaz 4y agoAs I see it, it is not a tank, but rather a manifold to support the two valves/taps. An example of a "modern" one (similar ones in plumbing are still hand made on the spot with pipes, but this is a pre-fabricated one): https://media-www.canadiantire.ca/product/fixing/plumbing/rough-plumbing/0631319/4-outlete-manifold-copper-25861199-e552-4101-8548-5cc251a1b9e5.png?imwidth=1024 https://media-www.canadiantire.ca/product/fixing/plumbing/ro...
- cryptonector 4y agoThe proportions are weird, which is what made me wonder. But sure.