3 ms·
Not only that, but after some digging it seems that the GPIO header is actually not half bad either despite it being somewhat small: https://wiki.odroid.com/_de
by moffkalast 4y ago
Not only that, but after some digging it seems that the GPIO header is actually not half bad either despite it being somewhat small: https://wiki.odroid.com/_detail/odroid-h3/hardware/h3_24pinmap.png?id=odroid-h3%3Ahardware%3Aio_expansion_gpio https://wiki.odroid.com/_detail/odroid-h3/hardware/h3_24pinm...
Supports i2c, UART, USB, and hopefully manual pin control too. That's already miles ahead of a NUC in terms of interfacing.
- eqvinox 4y ago> Supports i2c, UART, USB, and hopefully manual pin control too. From the set of pins provided I wouldn't get any hopes up for manual pin control. All pins are single-function, USB pins are almost never switchable (because they're high-speed analog-ish PHY functions), and UART & I2C are not GPIO-capable functions on most x86 platforms.
- moffkalast 4y agoWell that sucks if true, but at least an i2c GPIO expander/servo board is not out of the question I guess.