4 ms·
For it to work, each of the drives would have to be both a mass storage device and a USB hub. Can USB hubs be this small? If each segment has to be 3 inches lon
by dangrossman 15y ago
For it to work, each of the drives would have to be both a mass storage device and a USB hub. Can USB hubs be this small? If each segment has to be 3 inches long to accomodate the dual functionality, a foot long chain of USB drives sticking out the side of your laptop is a bit less elegant than the concept.
- dangero 15y agoThere's also the problem of power. I doubt these devices could be usb spec compliant since what is essentially happening here is an endless chain of bus powered usb hubs. It is pretty though.
- miahi 15y agoIt's not even the first time it was "dreamed" by some designer, with no technical consideration. You cannot actually do that in a standard way. Dan has a nice article on this: http://dansdata.blogsome.com/2010/03/23/for-suitably-small-values-of-infinite/ http://dansdata.blogsome.com/2010/03/23/for-suitably-small-v...
- rbanffy 15y agoUnless you want to attach a hard drive to the end of the line, power should be no big problem. I can't imagine the power requirements of a USB hub being that big.
- shabble 15y agoI don't think size would be much of an issue. Random googling finds USB2512[1] which comes in a 6mm x 6mm QFN package. It needs a crystal and a few caps. There's probably an equally tiny flash + USB SoC around to bolt onto it. The hard part would be the board layout (USB2 requires some line impedance matching, afaik) and the actual packaging. I reckon you could (conservatively) fit the necessary circuitry into 1 or 2 microSD sized cuboids, maybe one above the plug/socket, and one below. Maybe even less if you eschew some of the spec and only support daisy-chaining your own devices. [1] http://www.smsc.com/index.php?tid=295&pid=23&cid=&tab=1 http://www.smsc.com/index.php?tid=295&pid=23&cid=...