5 ms·
I'm reminded of what happened to solar hot water. It's now generally cheaper to use PV to drive a heat pump water heater. I suspect the same is true here -- u
by pfdietz 4y ago
I'm reminded of what happened to solar hot water. It's now generally cheaper to use PV to drive a heat pump water heater. I suspect the same is true here -- use PV to drive an ordinary refrigeration cycle. And PV, unlike the concentrating collectors shown here, also works with sunlight scattered off clouds and clear air.
- cjrp 4y agoCheaper to install or cheaper to run? My understanding was that the solar heaters were relatively cheap up-front.
- Aaargh20318 4y agoSure, but unlike PV "The construction of the ISAAC Solar Icemaker involves only welding, piping and sheet metal work, and there are no expensive materials." So this can be produced and maintained/repaired with much simpler tools, that makes it much more feasible to use in remote area's or developing countries.
- calvinmorrison 4y agoOr more so that mechanical refrigeration (as opposed to river ice extraction and shipping) may be a small scale technology that could exist past supply chain collapse
- KennyBlanken 4y agoNo expensive materials but it costs $7,000
- ncmncm 4y agoMostly labor, no doubt. $7000/12 is $583, so not cheaper than a regular refrigerator, but it uses no fuel or electricity, which for a dozen refrigerators would run over $4000/yr.
- pfdietz 4y agoAnd it uses concentrating collectors. That involves moving parts there, to track the sun. Are they assuming the tracking system is manufactured locally, or were they assuming manual tracking? Talk about labor intensive.
- pfdietz 4y agoAlternately, observe that PV is going to be like window glass -- a product for which transport costs become very important, so it will be made in facilities close to where it is used. The 3rd world should have PV factories.
- bilsbie 4y agoWhy is it cheaper?
- solardev 4y agoRapid R&D, weird economies of scale, Chinese subsidies, dumping, etc. PV modules are very cheap these days (often < $1/watt for the modules themselves, then maybe another $1 to $1.50 for the rest of the costs). There are also installers everywhere. For solar water heating, the nice ones use special vacuum-insulated collectors that are expensive in and of themselves, then you have to pipe all that liquid somewhere, through the roof, often to a special water heater made to accommodate a second heat source. Or have a roof strong enough to have a rooftop water tank. And you have to worry about freezing. In general these aren't common in the USA anymore, but are elsewhere (a 2012 report analyzing reasons https://www.nrel.gov/docs/fy12osti/54793.pdf https://www.nrel.gov/docs/fy12osti/54793.pdf) As the PV economies of scale ramp up, it's easier to just drop that onto any house (no major retrofits needed, just a few roof holes and a quick electrician approval) and use an electric, possibly tankless, water heater to do the job. The side benefit of that is that you don't have to worry about shunting waste heat. If you generate too much electricity, you just sell it to the grid and/or put it in batteries. You can have both, but with limited roof space, it's often easier just to get PV. If the costs & paybacks are similar, PV is a lot less maintenance than SWH and is more widely available using commodity components.
- bilsbie 4y agoThanks for the explanation. I suppose you could also have a DC water heater and get some efficiency from not turning the solar electricity into AC?
- solardev 4y agoYes, you could, like this: https://www.esmagazine.com/articles/102597-low-cost-direct-solar-pv-water-heating https://www.esmagazine.com/articles/102597-low-cost-direct-s... I would say the best setup depends on your goals, e.g. "save as much money as I can" vs "be totally off-grid and self-sustaining" vs "have a superbly engineered system that I personally designed but nobody else can understand or maintain". Starting from a finite roof area, you can install X modules. The higher-efficiency ones (meaning more power per square area) are more expensive. Then you have system efficiency losses from everything from DC/AC inversion (as you pointed out) to wiring to temperature to cloud cover to dust to sunlight angles, whatever. Ballpark, you can expect to get roughly 80% efficiency (meaning you can expect 80% of the array's nameplate output -- the sum of what your modules' wattage is listed as -- to be usable power that your loads can use). If you're going to throw batteries in there, you would lose a bit more efficiency, especially as time goes on. Example 1: All you care about is hot water If for some reason you don't care about the rest of your power draws in your house, you can fill your roof entirely with PV modules (generates electricity) or solar thermal collectors (sunlight heats a coolant, coolant gets pumped inside and a heat exchanger heats your water tank), then have the entirety of your production go towards your water heater. Excess heat beyond your temperature setpoint has to get shunted somewhere (so you don't boil yourself alive) and is generally wasted, unless you can heat exchange it with some other home heating system (radiant floor heating, for example). Otherwise you might just have one really hot utility room or dump the heat back outside. This is a super simple system, but you're essentially losing out on all the excess production. Example 2: If you want to optimize payback by selling back to the grid The most common residential PV systems are simple grid-tied ones where you generate power and buy/sell from/to the grid as needed. These days 300W+ modules are very common, so many households can generate more power on their roofs than they need, especially during the summer. Depending on your local electric utility and power buyback rate regulations and how they interact with time-of-use billing, it may make sense to either sell back to the grid all the time, or sometimes bank that excess production in a battery bank/electric car/supplemental heat for a water heater, etc. until you can sell back at a higher rate. It becomes a game of power arbitrage and you're basically a small power plant for the utility to buy from. Example 3: You don't want to be connected to the grid at all The math for this changes a bit because you're no longer concerned about time-of-use or selling back electricity, you probably just want the most days of autonomy you can get (i.e. how many cloudy days you can withstand before the lights go dark). That's a trickier formula involving your roof space, sum of your household average loads, your peak draws (do you need to run power tools or an electric stove/heater/air pump), the sunshine-days (average insolation) in your area, etc. From there you'd work backwards, figure out an appropriate battery bank size (due to chemistry, li-ion and lead-acid batteries have optimal depths of discharge you want to calculate for), maybe get the highest-efficiency modules you can find, etc. Other examples: AC-coupled hybrid on/off grid systems (to survive power outages but also be able to sell to the grid), DC-direct households (like you can use DC appliances and lighting, such as those made for RVs, throughout your offgrid cabin), ground mounts to add additional PV modules if you have a lot of electric cars or whatever, tilt-mount axes (not as popular anymore because it's cheaper to just add modules), microinverters and power optimizers to maximize the per-module output on a curve... it can get super complicated if you really want it to. But I'd caution against unnecessary overengineering. If you go with a bog-standard grid-tied setup, not only will it be the cheapest (probably), you can more easily repair/replace components as they wear out in the future. Batteries have the most limited lifespan (10 years? maybe more if you use modern chemistry and manage it really well), followed by inverters (15-25 years?)... the modules themselves are probably going to outlast the rest of the system. If you make something super complicated, it's going to be harder to find people who can maintain or replace it as it ages. Solar is not a especially high-margin business, so resellers and installers go in and out of business all the time, and if you have something really nonstandard, you'll have to pay extra for specialist engineers who can understand your particular setup vs any standard solar install crew. But it's a cool field... have fun and sorry for being so longwinded, lol
- Cthulhu_ 4y agoIn warmer countries - I've seen them in Greece and Turkey - solar boilers are on pretty much every roof, they're all collectors and a tank of I presume oil or some other medium, like on this stock photo: https://www.123rf.com/photo_16565679_solar-collector-tank-container-for-water-heating-and-water-on-solar-panels.html https://www.123rf.com/photo_16565679_solar-collector-tank-co... I believe PV also stops working effectively at higher temperatures or more intense solar radiation; I haven't seen much solar power down there.
- jaclaz 4y agoYep, also, say, Israel, Tunisia, in practice most of south mediterranean countries, basically anywhere houses have terrace roofs. The tank is just a water boiler, to store the heated water and usually (not always) it has a resistance heater for those few cases/days when hot water from sun heating is not enough. The only issues with these is that they are suitable for single homes (or however small, self-standing,) as the water pipes have to go up to the roof and back, the commmon ones are pumpless[1] (so multi-stores/multi-apartments becomes a problem), though they do make much more complex systems (with pumps, mixers. etc.) for such buildings. Example (from a Greek manufacturer): https://www.andrianos.gr/en/products/solar-thermal/solar-water-heaters https://www.andrianos.gr/en/products/solar-thermal/solar-wat...
- pfdietz 4y agoPV's efficiency declines a bit at high temperature, or at least that of Si does. Higher bandgap materials do better (CdTe is the commercialized one). That you have seen solar water heaters in some countries doesn't mean they're still a good idea there. The technologies have been changing rapidly.
- oldsecondhand 4y agoThe plus side of solar water heater is that the materials are much cheaper. In countries where there's no frost in winter it's a nobrainer.