3 ms·
No problem, thanks for asking. Plunger starts on the bottom with rubber side up. Put cylinder on top. Fill with water. Cap/filter (I use a metal mesh) on tight
by latchkey 4y ago
No problem, thanks for asking.
Plunger starts on the bottom with rubber side up. Put cylinder on top. Fill with water. Cap/filter (I use a metal mesh) on tight.
Then, invert with cap/filter on top of the cup. This is where you can pull the plunger out. Let it drip into the cup until halfway down the cylinder and then fill with more hot water. Put the plunger on top again 'a bit longer' (minute?) to stop the drip and let the newly added water brew. Then press the plunger in.
This way, I get a larger cup of coffee than the aeropress normally makes and not much dilution since the water still goes through the grinds. =)