3 ms·
I had a similar problem replacing some deck boards. Mine where Philips heads. I was able to get some out with a manual impact driver and later some out with an
by tzs 4y ago
I had a similar problem replacing some deck boards. Mine where Philips heads.
I was able to get some out with a manual impact driver and later some out with an electric impact driver. I had quite a few though that this didn't work on.
What I ended up doing, which only works if you don't need to avoid damaging the board, was use a wood chisel to clear remove the wood around the screw head. I then gripped the exposed head tightly with locking pliers roughly perpendicular to the axis of the screw. It was then fairly easy to turn the screws.
A small number of the heads broke off, but the locking pliers had no trouble turning those by the shaft instead.
I used Milwaukee locking pliers [1]. Unlike most locking pliers where the locking knob is designed to only be turned directly by hand, the Milwaukee locking knob has a hole through it meant to allow you to stick a metal rod such as a screwdriver through it and use that to get a lot more torque for turning the knob than you can get by hand [2]. You can get an insanely tight lock this way.
I only had one screw that this failed with. That one broke off low enough to leave nothing exposed above the bottom board. For that one I just left it in and made sure to place the replacement screw slightly to the side so it would go into wood instead of hitting the old screw.
[1] https://www.milwaukeetool.com/Products/Hand-Tools/Pliers/Locking-Pliers https://www.milwaukeetool.com/Products/Hand-Tools/Pliers/Loc...
[2] https://www.youtube.com/watch?v=4piwT_Z12uw https://www.youtube.com/watch?v=4piwT_Z12uw
- jefftk 4y ago> Unlike most locking pliers where the locking knob is designed to only be turned directly by hand, the Milwaukee locking knob has a hole through it meant to allow you to stick a metal rod such as a screwdriver through it and use that to get a lot more torque for turning the knob than you can get by hand [2]. You can get an insanely tight lock this way. Why not open the pliers, tighten the knob, then close the pliers again? You have lots of leverage in closing the pliers; do you need even more than that?
- tzs 4y agoI don't know if more than that is needed. I had never needed locking pliers before replacing those deck boards. Home Depot had several from Milwaukee and Husky, plus a couple from Stanley. The Milwaukee ones generally had better customer ratings, and some YouTube reviews I found liked them and mentioned the tightness of the lock you can get due to the screwdriver slot. I couldn't think of any situation where that would be a hindrance and it might be helpful in some situations, so I went with them. Also, the "t" in "tzs" stands for "Tim" so I was sort of obligated to go for more power. :-)