3 ms·
One thing I'd be careful about with newer machines is the storage is getting fast enough that many tasks that a few years ago would dramatically slow down if th
by tzs 4y ago
One thing I'd be careful about with newer machines is the storage is getting fast enough that many tasks that a few years ago would dramatically slow down if the system had to swap now only slowdown a little or even not at all. (This applies both to Mac and PC).
I've seen plenty of tests where people would get two or three M1 Macs configured identically except for amount of RAM and put them all through the same load tests, and not see performance differences anywhere near what most of us would expect. What they do so is that the low RAM machine is swapping a lot, the medium RAM machine is swapping a little, and the high RAM machine is not.
I'd worry that if I got a machine with just the amount of RAM I need to not see noticeable slowdowns during my more intense workloads, and with just enough storage for what I actually use with some room for growth, it will swap and even though I might not be noticing it will be increasing wear on storage.
AppleCare, which can now be renewed indefinitely instead of limited to just adding 2 years of coverage past the standard warranty, does not look like it covers SSD wear, and an out of coverage SSD replacement on most Macs nowadays I believe would be a logic board replacement which is not cheap. The Mac Studio has the storage modules on separate cards plugged into sockets on the main board, so maybe it will be relatively cheap to get Apple to replace those when the originals wear out, but that's still just speculation.
Thus, if you are buying a Mac and you want to keep using it for many years it might be worth considering SSD wear. There are two ways to reduce it. One is to get enough RAM to handle your workloads without any swapping--and don't forget that if you plan on using the machine for years to allow for growth in your work. I think I'd figure out the minimum RAM needed to not have more than minimal slowdowns from swapping, then double that twice (if possible). One doubling to stop swaps, and one doubling to allow room for future needs while remaining swap free.
The other way to reduce SSD wear is to get a bigger SSD. Generally the bigger the SSD the more total blocks can be written before it starts to fail.
I'd avoid getting smaller RAM and smaller SSD together unless I was going to just run the system itself off the built in storage and have all the user stuff on external drives.
- jbirer 4y agoThat's an easy way to reach max writes for your SSD and have to buy a new Macbook.