3 ms·
Power outage at my house right now and I have my fridge running off the 1500W outlet on my Mitsubishi Outlander PHEV. Only an 8kWH battery but it’s good enough
by cmrdporcupine 4y ago
Power outage at my house right now and I have my fridge running off the 1500W outlet on my Mitsubishi Outlander PHEV. Only an 8kWH battery but it’s good enough to run the fridge just wish I could run my well pump as well because no running water really is the worst. And when the battery depletes the cars ICE kicks in as a generator.
This kind of thing is only going to get more necessary as the weather becomes more volatile. This outage is likely fallout from the historic storm that went through Ontario and Quebec a bit over a week ago.
- danans 4y agoHmm, my Outlander PHEV doesn't have the 1500W outlet - I must have a lower trim. Cool that you can do it though. I believe there was a demonstration of using this vehicle as a backup generator during an outage, but I don't think it was ever commercialized.
- cmrdporcupine 4y agoYeah it's annoying it's only on the upper trims. I pushed my wife to spring for the upper trim and while I find many things about this vehicle disappointing (compared to my Volt which is far superior, technically), the outlets are handy. The thing is though that the Outlander has a CHADeMO port (strangely, I can't imagine ever using it to charge). CHADeMO is bidirectional. In theory a vehicle-to-house system could be built with it, providing 400V DC which you could run through whatever inverter you want. I say in theory because it doesn't seem like there are commercial products out there that will do this at this time. And CHADeMO is now a dead standard. But YouTuber sensation Benjamin Nelson has done it DIY with his iMiEV: https://www.youtube.com/watch?v=hBV9CIVN0fs https://www.youtube.com/watch?v=hBV9CIVN0fs ... but I can't say personally I'm eager to DIY it myself, because, well, 400V is scary. My power is now back on :-)
- danans 4y ago> The thing is though that the Outlander has a CHADeMO port (strangely, I can't imagine ever using it to charge). I read that it was a requirement by the Japanese government to have Bi-di charging to prepare for situations where the grid went down due to emergencies (i.e. earthquakes). It's pretty silly for rapid charging though, since you should only add 80% to a measly 8kWh battery. I've done it just to entertain myself when I run across a CHADeMO Electrify America station. > Benjamin Nelson has done it DIY with his iMiEV: https://www.youtube.com/watch?v=hBV9CIVN0fs https://www.youtube.com/watch?v=hBV9CIVN0fs ... but I can't say personally I'm eager to DIY it myself, because, well, 400V is scary. Nifty, but yeah, I'm not messing w/ hacking 400V either.
- xnyan 4y agoIt may be possible to run it off of a 1500w AC source. Compressors/pumps need a lot of current for a very short period of time to start, and much less power to run. Sometimes you can use electronic trickery to "soft start" a pump, Google "soft start" + your water pump - if your pump is 1/2hp or less, it's likely possible to run the pump off a 1500w supply. Alternatively, you can add a pressurized well tank for $300-500 usd that will supply you with 25-35 gallons of water without power. Not an unlimited supply, but even a little water is much better than none.
- cmrdporcupine 4y agoThe existing pump is likely running off 230V while the Outlander provides 120V AC. I'd also need to rewire it all so I can actually plug it in. I do have a pressure tank already (which is actually due to be replaced). But it's really only enough just for a few hand washings (and accidental toilet flushings) and then we end up out. Long run I want a more resilient setup. As soon as I start working again I want to get quotes on a solar panel setup for on my shop, and hopefully some kind of battery backup. Or even better or in addition, a CHADeMO V2H into the house so I can run the whole house off the Outlander.